SN54/74LS196
SN54/74LS197
4-STAGE PRESETTABLE
RIPPLE COUNTERS
TheSN54/74LS196decadecounterispartitionedintodivide-by-twoanddi-
vide-by-five sections which can be combined to count either in BCD (8, 4, 2, 1)
sequence or in a bi-quinary mode producing a 50% duty cycle output. The
SN54/74LS197 contains divide-by-two and divide-by-eight sections which
can be combined to form a modulo-16 binary counter. Low Power Schottky
technology is used to achieve typical count rates of 70 MHz and power dis-
sipation of only 80 mW.
4-STAGE PRESETTABLE
RIPPLE COUNTERS
LOW POWER SCHOTTKY
Both circuit types have a Master Reset (MR) input which overrides all other
inputs and asynchronously forces all outputs LOW. A Parallel Load input (PL)
overrides clocked operations and asynchronously loads the data on the Par-
allel Data inputs (P ) into the flip-flops. This preset feature makes the circuits
n
J SUFFIX
CERAMIC
CASE 632-08
usable as programmable counters. The circuits can also be used as 4-bit
latches, loading data from the Parallel Data inputs when PL is LOW and stor-
ing the data when PL is HIGH.
14
1
• Low Power Consumption — Typically 80 mW
• High Counting Rates — Typically 70 MHz
• Choice of Counting Modes — BCD, Bi-Quinary, Binary
• Asynchronous Presettable
• Asynchronous Master Reset
• Easy Multistage Cascading
N SUFFIX
PLASTIC
CASE 646-06
14
• Input Clamp Diodes Limit High Speed Termination Effects
1
CONNECTION DIAGRAM DIP (TOP VIEW)
D SUFFIX
SOIC
CASE 751A-02
14
1
NOTE:
The Flatpak version
has the same pinouts
(Connection Diagram) as
the Dual In-Line Package.
ORDERING INFORMATION
SN54LSXXXJ
Ceramic
SN74LSXXXN Plastic
SN74LSXXXD SOIC
PIN NAMES
LOADING (Note a)
LOGIC SYMBOL
HIGH
LOW
1.5 U.L.
CP
Clock (Active LOW Going Edge)
Input to Divide-by-Two Section
Clock (Active LOW Going Edge)
Input to Divide-by-Five Section
Clock (Active LOW Going Edge)
Input to Divide-by-Eight Section
Master Reset (Active LOW) Input
Parallel Load (Active LOW) Input
Data Inputs
1.0 U.L.
0
CP (LS196)
2.0 U.L.
1.0 U.L.
1.75 U.L.
0.8 U.L.
1
CP (LS197)
1
MR
PL
1.0 U.L.
0.5 U.L.
0.5 U.L.
10 U.L.
0.5 U.L.
0.25 U.L.
P –P
0
0.25 U.L.
3
Q –Q
Outputs (Notes b, c)
5 (2.5) U.L.
0
3
NOTES:
a. 1 TTL Unit Load (U.L.) = 40µA HIGH/1.6 mA LOW.
b. The Output LOW drive factor is 2.5 U.L. for Military (54) and 5 U.L. for Commercial (74)
b. Temperature Ranges.
c. In addition to loading shown, Q can also drive CP .
0
1
FAST AND LS TTL DATA
5-372