Surface Mount Transient Voltage Suppressors (TVS)
5.0SMDJ Series
11 To 440 V
5000W
Uni-directional
Bi-directional
Description
The 5.0SMDJ series is designed specifically to protect sensitive electronic
equipment from voltage transients induced by lightning and other transient
voltage events.
Features
u
For surface mounted applications in order to optimize board space
Low leakage
u
u
u
u
u
u
Uni and Bidirectional unit
Glass passivated junction
Low inductance
Excellent clamping capability
5000W Peak power capability at 10 × 1000µs waveform Repetition
rate (duty cycle):0.01%
Functional Diagram
u
u
u
u
Fast response time: typically less than 1.0ps from 0 Volts to VBR min
Typical IR less than 5μA above 25V.
High Temperature soldering: 260°C/40 seconds at terminals
Typical maximum temperature coefficient ΔVBR = 0.1% ×
VBR@25°C× ΔT
Bi-directional
Cathode
Anode
u
u
u
u
u
Plastic package has Underwriters Laboratory Flammability 94V-0
Matte tin lead–free Plated
Uni-direction
Halogen free and RoHS compliant
Typical failure mode is short from over-specified voltage or current
Whisker test is conducted based on JEDEC JESD201A per its table
4a and 4c
Applications
u
u
IEC-61000-4-2 ESD 15kV(Air), 8kV (Contact)
ESD protection of data lines in accordance with IEC 61000-4-2
(IEC801-2)
TVS devices are ideal for the protection of I/O interfaces, VCC
bus and other vulnerable circuits used in Telecom, Computer,
Industrial and Consumer electronic applications.
u
EFT protection of data lines in accordance with IEC 61000-4-4
(IEC801-4)
Maximum Ratings (TA=25℃ unless otherwise noted)
Parameter
Symbol
Value
Unit
Peak Pulse Power Dissipation with a 10/1000µs waveform (Fig.1)(Note
PPPM
5000
Watts
1), (Note 2)
Peak Pulse Current with a 10/1000µs waveform.(Note1,Fig.3)
Power Dissipation on Infinite Heat Sink at TL=75°C
IPP
PM(AV)
IFSM
See Next Table
Amps
Watt
6.5
Peak Forward Surge Current, 8.3ms Single Half Sine Wave (Note 3)
300
Amps
Maximum Instantaneous Forward Voltage at 25A for Unidirectional Only
(Note 4)
VF
3.5/5.0
Voltage
Operating junction and Storage Temperature Range.
TJ , TSTG
-55 to +150
°C
Notes:
1. Non-repetitive current pulse, per Fig. 3 and derated above TA = 25°C per Fig. 2.
2. Mounted on 5.0mm x 5.0mm (0.03mm thick) Copper Pads to each terminal.
3. 8.3ms single half sine-wave, or equivalent square wave, Duty cycle = 4 pulses per minutes maximum.
4. VF < 3.5V for VBR < 200V and VF< 6.5V for VBR > 201V.
SOCAY Electronics Co., Ltd.
www.socay.com
@ SOCAY Electronics Co., Ltd. 2013
Specifications are subject to change without notice.
Please refer to www.socay.com for current information.
Revision September 25, 2013
1 / 7