Application Specification
114-10011
Audio/Microphone Connectors
18 Mar 11 Rev C
All numerical values are in metric units [with U.S. customary units in brackets]. Dimensions are in millimeters [and
inches]. Unless otherwise specified, dimensions have a tolerance of +0.13 [+.005] and angles have a tolerance of +2_.
Figures and illustrations are for identification only and are not drawn to scale.
NOTE
i
1. INTRODUCTION
This specification covers the requirements for the application of Audio/Microphone Connectors. The connectors
are designed to accept a wire size range of 18 through 28 AWG and are available in 4, 5, or 6 position. The
receptacle connector is panel mounted. Application may be done by machine for reel--mounted contacts and
by hand for replacement loose piece contacts.
‘When corresponding with TE Personnel, use the terminology provided on this specification to help facilitate
your inquiry for information. Basic terms and features of components are provided in Figure 1.
Socket Contact
Mounting Fins
Polarizing Rib
(On Mating Face)
Locking Collar
Strain Relief
Collets
Engagement
Groove
Front (Ref)
Antirotation
Key
Locking Latch
Pin Contact
Polarizing
Groove
6-Position Receptacle
Housing (Typ)
Locking Tab
Entry Slot
Locking Tab
Plug Insert
Numbered
Contact
Cavities
Latch Slot
Alignment
Groove
Detent
Plug Body
Flexible Cable Guard
Figure 1
E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
TOOLING ASSISTANCE CENTER 1--800--722--1111 This controlled document is subject to change.
1 of 11
All Rights Reserved
PRODUCT INFORMATION 1--800--522--6752
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks.
*Trademark. Other logos, product and/or Company names may be trademarks of their respective owners.
LOC B