5秒后页面跳转
23-80405 PDF预览

23-80405

更新时间: 2024-10-29 00:53:11
品牌 Logo 应用领域
其他 - ETC 有线电视
页数 文件大小 规格书
16页 2506K
描述
Drop Wire Clamps for CATV and Telephone Cable

23-80405 数据手册

 浏览型号23-80405的Datasheet PDF文件第2页浏览型号23-80405的Datasheet PDF文件第3页浏览型号23-80405的Datasheet PDF文件第4页浏览型号23-80405的Datasheet PDF文件第5页浏览型号23-80405的Datasheet PDF文件第6页浏览型号23-80405的Datasheet PDF文件第7页 
A
BELDEN
BRAND  
Diamond® Drop Hardware  
Drop Wire Clamps for CATV and Telephone Cable  
Universal Messenger Cable Drop Wire Clamp  
Permits cable to “float” free, fully protected from strain and chafing.  
Drop clamp for the suspension of a messengered drop cable between the  
pole, midspan and house.  
For use with RG59, RG6 and other cables  
Stainless steel bail wire and aluminum body.  
Inner  
Pack  
Outer  
Pack  
Part Number  
SC02MFA-SS  
Description  
Universal Messenger Drop Wire Clamp  
--  
125  
Installation:  
1. Begin separation of the messenger wire from the  
cable using the end-edge of the SC02MFA-SS Drop  
Clamp.  
1
2
Note: Never use a knife or other sharp tool to  
separate messenger and cable.  
2. Fit the cable and messenger wire into the SCO2MFA-  
SS Drop Clamp as shown, so that the Clamp Bail is  
between the two.  
3. Grasp the separated end of the messenger and cable  
with one hand and grip the Clamp Body, as shown,  
with your other hand. Then, pull the SC02MFA-SS  
back, in a straight line, separating the length of  
messenger wire needed to make the wrap; about 15  
to 18-inches.  
3
4
4. Pull the messenger wire around the center of the  
bearing surface as shown, toward the rear or drop-  
side of the Clamp.  
Note: If at the house end of the drop, this will be  
done while tensioning or “sagging” the drop.  
5
5. Pass the messenger wire through the “L” Slots and  
begin the wrap about the SC02MFA-SS body, as  
shown.  
6. Continue the messenger wire wrap for two full turns.  
7. Pass the messenger wire through the “L” Slot, as  
shown, to the drop-side of the SC02MFA-SS and cut  
the excess wire away, or ground it to the strand.  
6
7
Note: For drop cable with larger messenger wire, one  
wrap is sufficient. Wrap the end of the wire around  
the end of the SC02MFA-SS and bring it back up the  
“L” Slots, then cut away the excess, or ground it to  
the strand.  
www.ppc-online.com  
Customer Support: 800.800.6652  
6
A
BELDEN BRAND  

与23-80405相关器件

型号 品牌 获取价格 描述 数据表
23-80406 ETC

获取价格

Drop Wire Clamps for CATV and Telephone Cable
23-80407 ETC

获取价格

Drop Wire Clamps for CATV and Telephone Cable
238041801 GENERAL

获取价格

Sound, Alarm & Security Cable
238048 RICHCO

获取价格

SOFT PVC(RMS-55)
2380-500-15 TEKTRONIX

获取价格

Programmable DC Electronic Loads
2380-500-30 TEKTRONIX

获取价格

Programmable DC Electronic Loads
2380-5121-TB 3M

获取价格

80 CONTACT(S), MALE, RIGHT ANGLE TWO PART BOARD CONNECTOR, SOLDER
2380-5121TG 3M

获取价格

80 CONTACT(S), MALE, RIGHT ANGLE TWO PART BOARD CONNECTOR, SOLDER
2380-5121TN 3M

获取价格

Board Connector, 80 Contact(s), 2 Row(s), Male, Right Angle, 0.1 inch Pitch, Solder Termin
238051801 GENERAL

获取价格

Sound, Alarm & Security Cable