07 | Keysight | Probing Solutions for Logic Analyzers - Data Sheet
Probe Selection Guide for All Keysight Logic Analyzers (Continued)
U4200A Series direct-connect probes selection guide
Direct connect probes connect directly to the DUT and the 160-pin front panel connector of the compatible logic analyzers listed
below.
Logic analyzer compatibility
– U4164A, U4154A/B
– 16850A Series
Note: The U4206A is for use only with the U4164A when in quad sample state mode or ¼ channel timing mode.
Soft touch connectorless probes
U4206A (see note above) U4204A
Mictor probe
U4205A
General purpose flying lead
set
U4203A
Model number
Application
Quick connection to many channels in a small footprint without Quick connection to many
Flexible connection to individual
signals
34
32 data, 2 clock
Differential or single-ended
clock, single-ended data
1.5 Gb/s
a header designed into the target system
signals in a small footprint
34
Number of channels 34
32 data, 2 clock
Supported signal
types
34
32 data, 2 clock
Differential or single-ended
clock, single-ended data
3.2 Gb/s
32 data, 2 clock
Single-ended clock, single-
ended data
Differential or single-ended
clock, single-ended data
Maximum data rate 4 Gb/s
600 Mb/s
Minimum signal
amplitude
V
max – Vmin
Vmax – Vmin
200 mV
Vmax – Vmin
200 mV
Vmax – Vmin
200 mV
300 mV/200 mV 1
Connection to
target system
Requires Pro Series soft touch Requires Pro Series soft touch Requires 38-pin Mictor
Compatible with a wide
assortment of accessories to
connect to individual leads
< 0.9 pF
footprint designed into the
target
footprint designed into the
target
connector designed into the
target system
Input capacitance
< 0.7 pF
< 0.7 pF
3.0 pF
Additional supplies Kit of 5 additional retention
modules
Kit of 5 additional retention
modules
See Table 1 for PC board
connectors and shrouds
See Figure for additional leads
and grabbers
Orderable as
E5403A
E5403A
1. 300 mV input required for data rates greater than 2.5 Gb/s.