108-2072
10 Sep 12 Rev E
Product
Specification
MULTIGIG RT* Signal Connectors, Tiers 1 and 2, RT2 Mezzanine,
and RT2 Ruggedized
1.
SCOPE
1.1.
Content
This specification covers performance, tests and quality requirements for the TE Connectivity (TE)
MULTIGIG RT* Signal connector system which uses a modular concept and interconnects two printed
circuit boards. Both receptacle and plug connectors are connected to the printed circuit boards with
plated thru-hole compliant press-fit leads. The connector system is designed to perform at two different
signal transmission performance levels which are identified by the “Tier” designator. Although signal
transmission performance levels vary between the “Tiers” of product, the mechanical and
environmental requirements contained in this specification apply to all.
1.2.
1.3.
Qualification
When tests are performed on the subject product line, procedures specified in Figure 1 shall be used.
All inspections shall be performed using the applicable inspection plan and product drawing.
Qualification Test Results
Successful qualification testing on Tier 1 product was completed on 14Aug02. Successful qualification
testing on Tier 2 product was completed on 31Jan04. Successful qualification testing on RT2
Mezzanine product was completed on 11Nov07. Successful qualification testing on the RT2
Ruggedized product was completed 20Aug2012. The Qualification Test Report number for this testing
is 501-544. This documentation is on file at and available from Engineering Practices and Standards
(EPS).
2.
APPLICABLE DOCUMENTS
The following documents form a part of this specification to the extent specified herein. Unless
otherwise specified, the latest edition of the document applies. In the event of conflict between the
requirements of this specification and the product drawing, the product drawing shall take precedence.
In the event of conflict between the requirements of this specification and the referenced documents,
this specification shall take precedence.
2.1.
2.2.
Tyco Electronics Documents
●
●
●
109 Series: Test Specifications as indicated in Figure 1
109-197: Test Specification (AMP Test Specifications vs EIA and IEC Test Methods)
501-544: Qualification Test Report (MULTIGIG RT* Signal Connectors, Tiers 1 and 2, RT2
Mezzanine, and RT2 Ruggedized.)
Commercial Documents
●
●
Bellcore GR-1217: Generic Requirements for Separable Electrical Connectors Used in
Telecommunications Hardware
EIA-364: Electrical Connector/Socket Test Procedures Including Environmental Classifications
©2012 Tyco Electronics Corporation, a TE Connectivity Ltd. company
All Rights Reserved
| Indicates Change
1 of 11
*Trademark. TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or company names may be trademarks of their respective owners.