TM
ICmic
1024 x 8 Bit
This X25097 device has been acquired by
IC MICROSYSTEMS from Xicor, Inc.
IC MICROSYSTEMS
8K
X25097
5MHz Low Power SPI Serial E2PROM with IDLockTM Memory
DESCRIPTION
FEATURES
The X25097 is a CMOS 8K-bit serial E2PROM, internally
organized as 1024 x 8. The X25097 features a Serial
•5MHz Clock Rate
•IDLock™ Memory
Peripheral Interface (SPI) and software protocol allowing
operation on a simple four-wire bus. The bus
—IDLock First or Last Page, any 1/4 or Lower 1/2 of
E2PROM Array
•Low Power CMOS
—<1µA Standby Current
—<3mA Active Current during Write
—<400µA Active Current during Read
signals are a clock input (SCK) plus separate data in (SI) and
data out (SO) lines. Access to the device is
controlled through a chip select (CS) input, allowing any
number of devices to share the same bus.
•1.8V to 3.6V, 2.7V-5.5V or 4.5V to 5.5V Operation
•Built-in Inadvertent Write Protection
IDLock is a programmble locking mechanism which allows
the user to lock system ID and parametric data in
different portions of the E2PROM memory space, ranging
from as little as one page to as much as 1/2 of
—Power-Up/Power-Down Protection Circuitry
—Write Enable Latch
—Write Protect Pin
•SPI Modes (0,0 & 1,1)
•1024 x 8 Bits
the total array. The X25097 also features a WP pin that can
be used for hardwire protection of the part, disabling
all write attempts, as well as a Write Enable Latch that must be
set before a write operation can be initiated.
—16 Byte Page Mode
•Self-Timed Write Cycle
The X25097 utilizes Xicor’s proprietary Direct WriteTM cell,
providing a minimum endurance of 100,000 cycles
per byte and a minimum data retention of 100 years.
—5ms Write Cycle Time (Typical)
•High Reliability
—Endurance: 100,000 Cycles/Byte
—Data Retention: 100 Years
—ESD: 2000V on all pins
•8-Lead TSSOP Package
•8-Lead SOIC Package
•8-Lead PDIP Package
FUNCTIONAL DIAGRAM
DATA REGISTER
Y DECODE LOGIC
SI
SO
16
8
COMMAND
DECODE
X
64
SCK
DECODE
LOGIC
AND
CONTROL
LOGIC
8K E2PROM
ARRAY
(1024 x 8)
CS
HIGH VOLTAGE
CONTROL
WP
WRITE CONTROL LOGIC
7038 FRM F01
©Xicor, Inc. 1994, 1995, 1996 Patents Pending
7034-1.1 5/8/97 T1/C0/D0 SH
Characteristics subject to change without notice
1