Type V-730P
Vishay Sprague
Film Capacitors
High Frequency, Wrap-and-Fill, Metallized Polypropylene
FEATURES
• Excellent AC performance
• Low Power dissipation
• Low dielectric absorption
• Close tolerance
RoHS
COMPLIANT
• High stability
PERFORMANCE CHARACTERISTICS
Operating Temperature: - 55 °C to + 85 °C
Voltage derating:
DC Life Test: 150 % of rated voltage for 1000 hours
at + 85 °C. No open or short circuits. No visible damage.
Maximum Δ CAP 1.0 %
Minimum IR = 50 % of initial limit
Maximum DF = 0.12 %
At + 105 °C, 50 % of + 85 °C rating
ESR: 20 kHz to 100 kHz
Capacitance Range: 0.022 µF to 10.0 µF
Capactiance Tolerance: 20 %, 10 %, 5 %
DC Voltage Rating: 100 WVDC to 630 WVDC
AC Voltage Rating: 70 Vrms to 275 Vrms, 60 Hz to 400 Hz
Humidity Test: 95 % relative humidity at + 40 °C for 250
hours. No visible damage.
Maximum Δ CAP 1.0 %
Minimum IR = 20 % of initial limit
Maximum DF = 0.12 %
Dissipation Factor: 0.1 % maximum
Measure all units at 1000 Hz at + 25 °C
AC Life Test: 110 % of rated rms voltage at 60 Hz for 1000
hours at + 85 °C.
DC Voltage Test: 200 % of rated voltage for 2 minutes
AC Voltage Test: 130 % of rated rms voltage at 60 Hz for
15 seconds
Maximum Δ CAP 5 %
Minimum IR = 50 % of initial limit
Maximum DF = 0.12 %
Insulation Resistance: Measured at 100 WVDC after a
2 minute charge.
At + 25 °C: 200 000 Megohm - Microfarads
or 400 000 Megohm minimum.
At + 85 °C: 10 000 Megohm - Microfarads
or 20 000 Megohm minimum.
PHYSICAL CHARACTERISTICS
Lead Pull: 5 pounds (2.3 kilograms) for one minute. No
physical damage.
At + 105 °C: 1000 Megohm - Microfarads
or 2000 Megohm minimum.
Lead Bend: After three complete consecutive bends. No
damage.
Marking: Sprague® trademark, type or part number,
capacitance and voltage.
Vibration Test (Condition B): No mechanical damage,
short, open or intermittent circuits.
DIMENSIONS in inches [millimeters]
1.750
[44.45]
Min.
1.750
[44.45]
Min.
L
D
Max.
0.062 [1.57]
Solid Tinned Wire
0.032 [0.81] Nominal Dia.
(No. 20 AWG)
* Leads to be within 0.062" [1.57 mm] of center line at egrees but not less than 0.031" [0.79 mm] from edge.
Document Number: 42092
Revision: 16-Nov-07
For technical questions, contact: spresale@vishay.com
www.vishay.com
25