UWR Models
www.murata-ps.com
Single Output, High-Density,
6 Amp/15 Watt DC/DC Converters
Typical units
PRODUCT OVERVIEW
The new 1.2, 1.5V, 1.8V and 2.5V models in
Murata Power Solutions’ flagship 7-15 Watt
A-Series can source a continuous 6 Amps. This
is the most "low-voltage" current available from
a standard 1" x 2" package, and these power
converters exemplify Murata Power Solutions’
relentless drive to bring you more power/current,
from standard packages, without compromising
reliability or resorting to thermal specmanship.
By combining a high-frequency, high-efficiency
(to 88%), synchronous-rectifier topology with
the newest components and time-tested, fully
automated, SMT-on-pcb construction, these
UWR Models are able to bring you 7-15W (@
up to 6A) in the standard 1" x 2" package from
which most competitors can only get 5-10W (@
3-4A). All UWR’s deliver their full output power
over ambient temperature ranges from –40°C
to as high as +70°C (model and input voltage
dependent) without heat sinks or supplemental
forced-air cooling. Devices derate to +100°C.
Output voltages are 1.2, 1.5, 1.8, 2.5, 3.3, 5,
12 or 15 Volts. Input voltage ranges are 10-18V
(D12 models), 18-36V (D24 models) or 36-75V
(D48 models). All models feature input pi filters,
input undervoltage and overvoltage lockout, input
reverse-polarity protection, output overvoltage
protection, output current limiting, and continuous
short-circuit protection. On/off control and output-
trim functions are optional (see Optional Functions).
All models are designed to meet IEC950, UL1950
and EN60950-1, 2nd Edition safety requirements.
D48 models (36-75V inputs) are CE marked.
UWR 7-15W DC/DC’s are packaged in low-
cost, light-weight, diallyl phthalate (UL94V-0
rated) plastic packages with standoffs. EMC
compliance is achieved via a low-noise design
rather than through expensive metal shielding.
1.2-2.5VOUT models source 6 Amps
3.3VOUT models source 4.25 Amps
5/12/15VOUT models deliver full 15 Watts
Synchronous-rectifier topologies
Guaranteed efficiencies to 88%
Choice of 3 input voltage ranges:
10-18V, 18-36V, 36-75V
–40 to +60/70C ambient w/o derating
Fully isolated (1500Vdc); I/O protected
Meets UL/IE/EN60950-1 certification,
2nd Edition
CE mark (75VIN models)
Standard 1" x 2" packages and pinouts
Optional VOUT trim and on/off control
+VIN
(1)
+VOUT
(4)
SWITCH
CONTROL
COMMON
(6)
–VIN
(2)
PWM
CONTROLLER
OPTO
ISOLATION
REFERENCE &
ERROR AMP
TRIM
(5)
(OPTIONAL)
UVLO & OVLO
COMPARATORS
ON/OFF
CONTROL
(3)
Typical topology is shown.
(OPTIONAL)
Figure 1. Simplified Schematic
For full details go to
www.murata-ps.com/rohs
www.murata-ps.com/support
MDC_UWR_7-15.G04 Page 1 of 12