5秒后页面跳转
UDN2987X-6 PDF预览

UDN2987X-6

更新时间: 2024-11-18 03:11:07
品牌 Logo 应用领域
急速微 - ALLEGRO 驱动器过电流保护
页数 文件大小 规格书
9页 656K
描述
DABIC-5 8-Channel Source Driver with Overcurrent Protection

UDN2987X-6 数据手册

 浏览型号UDN2987X-6的Datasheet PDF文件第2页浏览型号UDN2987X-6的Datasheet PDF文件第3页浏览型号UDN2987X-6的Datasheet PDF文件第4页浏览型号UDN2987X-6的Datasheet PDF文件第5页浏览型号UDN2987X-6的Datasheet PDF文件第6页浏览型号UDN2987X-6的Datasheet PDF文件第7页 
UDN2987x-6  
DABIC-5 8-Channel Source Driver  
with Overcurrent Protection  
Package A, 20-pin DIP  
Package LW, 20-pin SOIC-W  
Features  
Providing overcurrent protection for each of its eight  
sourcing outputs, the UDN2987A-6 and UDN2987LW-6  
drivers are used as an interface between standard low-level logic  
and relays, motors, solenoids, LEDs, and incandescent lamps.  
These devices include thermal shut down and output transient  
protection/clamp diodes for use with sustaining  
voltages to 35 V.  
Approximate Scale 1:1  
In these drivers, each channel includes a latch to turn off  
that channel if the maximum channel current is exceeded. All  
channels are disabled if the thermal shutdown is activated. A  
common FAULT output is used to indicate either chip thermal  
shutdown or any overcurrent condition. All outputs are enabled  
4.75 to 35 V driver supply voltage  
Output enable-disable (OE/R)  
350 mA output source current  
Overcurrent protected  
Internal ground clamp diodes  
¯
by pulling the common OE/R input high. When OE/R is low,  
all outputs are inhibited and the eight latches are reset. The  
¯
OE/R function can be especially important during power-up, in  
Output Breakdown Voltage 35 V minimum  
TTL, DTL, PMOS, or CMOS compatible inputs  
Internal Thermal Shut Down (TSD)  
preventing floating inputs from turning on the outputs.  
Under normal operating conditions, each of eight outputs  
will source in excess of 100 mA continuously at an ambient  
temperature of 25°C and a supply of 35 V. The over-current  
fault circuit will protect the device from short-circuits to ground  
with supply voltages of up to 30 V.  
Applications  
Relays  
Motors  
Solenoids  
LEDs  
The inputs are compatible with 5 and 12 V logic systems:  
TTL, Schottky TTL, DTL, PMOS, and CMOS. In all cases, the  
output is switched ON by an active high input level. Compared  
to their predecessor devices, the UDN2987A and UDN2987LW,  
the UDN2987A-6 and UDN2987LW-6 have a significantly  
faster TPHL (200 ns typical) and a lower driver supply voltage  
rating (4.75 V), which allows the use of 5 V logic.  
Incandescent lamps  
Typical Application  
IN1  
OUT1  
OUT2  
OUT3  
OUT4  
OUT5  
OUT6  
OUT7  
OUT8  
GND  
IN2  
IN3  
The UDN2987A-6 is supplied in a 20-pin dual in-line plastic  
(DIP) package; the UDN2987LW-6 is supplied in a 20-lead  
small-outline (SOIC-W) plastic package. The Pb (lead) free  
versions have 100% matte-tin leadframe plating.  
IN4  
1 to 8 Load  
Components  
2987  
CPU  
IN5  
IN6  
IN7  
IN8  
FAULT  
¯
OE/R  
VS  
4.75 to 35 V  
29876DS  

与UDN2987X-6相关器件

型号 品牌 获取价格 描述 数据表
UDN2987X-6_12 ALLEGRO

获取价格

Providing overcurrent protection for each of its eight sourcing outputs, the UDN2987LW-6 d
UDN2993 ALLEGRO

获取价格

DUAL H-BRIDGE MOTOR DRIVERS
UDN2993B ALLEGRO

获取价格

DUAL H-BRIDGE MOTOR DRIVERS
UDN-2993B ETC

获取价格

DC Motor Controller/Driver
UDN2993LB ALLEGRO

获取价格

DUAL H-BRIDGE MOTOR DRIVERS
UDN-2993LB ETC

获取价格

PIN Diode Driver
UDN2998 ALLEGRO

获取价格

DUAL FULL-BRIDGE MOTOR DRIVER
UDN2998B ALLEGRO

获取价格

Brush DC Motor Controller, 3A, PSFM12, SIP-12
UDN2998W ALLEGRO

获取价格

DUAL FULL-BRIDGE MOTOR DRIVER
UDN-2998W ETC

获取价格

DC Motor Controller/Driver