5秒后页面跳转
UCC2884NG4 PDF预览

UCC2884NG4

更新时间: 2024-11-08 15:55:55
品牌 Logo 应用领域
德州仪器 - TI 信息通信管理开关光电二极管
页数 文件大小 规格书
12页 318K
描述
1A SWITCHING CONTROLLER, 750kHz SWITCHING FREQ-MAX, PDIP16, PLASTIC, DIP-16

UCC2884NG4 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Obsolete零件包装代码:DIP
包装说明:DIP, DIP16,.3针数:16
Reach Compliance Code:compliantECCN代码:EAR99
HTS代码:8542.39.00.01风险等级:5.69
模拟集成电路 - 其他类型:SWITCHING CONTROLLER控制模式:CURRENT-MODE
控制技术:PULSE WIDTH MODULATION最大输入电压:12 V
最小输入电压:10 V标称输入电压:11 V
JESD-30 代码:R-PDIP-T16长度:19.3 mm
功能数量:1端子数量:16
最高工作温度:85 °C最低工作温度:-40 °C
最大输出电流:1 A封装主体材料:PLASTIC/EPOXY
封装代码:DIP封装等效代码:DIP16,.3
封装形状:RECTANGULAR封装形式:IN-LINE
峰值回流温度(摄氏度):NOT SPECIFIED认证状态:Not Qualified
座面最大高度:5.33 mm子类别:Switching Regulator or Controllers
表面贴装:NO切换器配置:BUCK-BOOST
最大切换频率:750 kHz技术:BICMOS
温度等级:INDUSTRIAL端子形式:THROUGH-HOLE
端子节距:2.54 mm端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIED宽度:7.62 mm
Base Number Matches:1

UCC2884NG4 数据手册

 浏览型号UCC2884NG4的Datasheet PDF文件第2页浏览型号UCC2884NG4的Datasheet PDF文件第3页浏览型号UCC2884NG4的Datasheet PDF文件第4页浏览型号UCC2884NG4的Datasheet PDF文件第5页浏览型号UCC2884NG4的Datasheet PDF文件第6页浏览型号UCC2884NG4的Datasheet PDF文件第7页 
UCC2884  
UCC3884  
www.ti.com  
SLUS160BAUGUST 1999REVISED AUGUST 2007  
Frequency Foldback Current Mode PWM Controller  
1
FEATURES  
DESCRIPTION  
Frequency Foldback Reduces Operating  
Frequency Under Fault Conditions  
The UCC3884 is a high performance current mode  
PWM controller intended for single ended switch  
mode power supplies. The chip implements  
Accurate Programmable Volt-Second Clamp  
Programmable Maximum Duty Cycle Clamp  
Oscillator Synchronization  
a
frequency foldback scheme that decreases the  
oscillator frequency as the output voltage falls below  
a programmed value. This technique decreases the  
average output current sourced into a low impedance  
load which can occur during an output short circuit or  
overload condition. Excessive short circuit current is  
more prevalent in high frequency converters where  
the propagation delay and switch turn-off time forces  
Overcurrent Protection  
Shutdown With Full Soft Start  
Wide Gain Bandwidth Amplifier (GBW > 2.5  
MHz)  
Current Mode Operation  
Precision 5-V Reference  
a
minimum attainable duty cycle. An accurate  
volt-second clamp limits the duty cycle during line or  
load transient conditions which could otherwise  
saturate the transformer. The volt-second clamp may  
also be used with an external overvoltage protection  
circuit to handle fault conditions such as current  
sense disconnect or current transformer saturation.  
The frequency foldback, volt-second clamp,  
cycle-by-cycle current limit, and overcurrent shutdown  
provide a rich set of protection features for use in  
peak current-mode pulse width modulators.  
OSCILLATOR SYNCHRONIZATION  
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of  
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.  
PRODUCTION DATA information is current as of publication date.  
Products conform to specifications per the terms of the Texas  
Instruments standard warranty. Production processing does not  
necessarily include testing of all parameters.  
Copyright © 1999–2007, Texas Instruments Incorporated  

与UCC2884NG4相关器件

型号 品牌 获取价格 描述 数据表
UCC2884Q ETC

获取价格

Current-Mode SMPS Controller
UCC2884QTR TI

获取价格

1A SWITCHING CONTROLLER, 750kHz SWITCHING FREQ-MAX, PQCC20, PLASTIC, LCC-20
UCC2885D TI

获取价格

0.5A SWITCHING CONTROLLER, 400kHz SWITCHING FREQ-MAX, PDSO14
UCC2885DTR TI

获取价格

0.5A SWITCHING CONTROLLER, 400kHz SWITCHING FREQ-MAX, PDSO14
UCC2885J TI

获取价格

0.5A SWITCHING CONTROLLER, 400kHz SWITCHING FREQ-MAX, CDIP14
UCC2885N TI

获取价格

0.5A SWITCHING CONTROLLER, 400kHz SWITCHING FREQ-MAX, PDIP14
UCC2888 TI

获取价格

Off-line Power Supply Controller
UCC28881 TI

获取价格

700V 极低静态电流离线开关
UCC28881D TI

获取价格

700V 极低静态电流离线开关 | D | 7 | -40 to 125
UCC28881DR TI

获取价格

700V 极低静态电流离线开关 | D | 7 | -40 to 125