5秒后页面跳转
UCC28503DW PDF预览

UCC28503DW

更新时间: 2024-11-23 04:48:11
品牌 Logo 应用领域
德州仪器 - TI 功率因数校正信息通信管理控制器
页数 文件大小 规格书
31页 561K
描述
BICMOS PFC/PWM COMBINATION CONTROLLER

UCC28503DW 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Active零件包装代码:SOIC
包装说明:SOP, SOP20,.4针数:20
Reach Compliance Code:compliantECCN代码:EAR99
HTS代码:8542.39.00.01Factory Lead Time:1 week
风险等级:1.31其他特性:CAN ALSO BE PROGRAMMED FOR CURRENT MODE AND VOLTAGE MODE
模拟集成电路 - 其他类型:POWER FACTOR CONTROLLER WITH POST REGULATOR控制模式:CURRENT-MODE
控制技术:PULSE WIDTH MODULATION最大输入电压:15 V
最小输入电压:10.3 V标称输入电压:12 V
JESD-30 代码:R-PDSO-G20JESD-609代码:e4
长度:12.8 mm湿度敏感等级:2
功能数量:1端子数量:20
最高工作温度:85 °C最低工作温度:-40 °C
最大输出电流:1.2 A封装主体材料:PLASTIC/EPOXY
封装代码:SOP封装等效代码:SOP20,.4
封装形状:RECTANGULAR封装形式:SMALL OUTLINE
峰值回流温度(摄氏度):260认证状态:Not Qualified
座面最大高度:2.65 mm子类别:Switching Regulator or Controllers
最大供电电流 (Isup):4 mA最大供电电压 (Vsup):18 V
标称供电电压 (Vsup):12 V表面贴装:YES
切换器配置:BOOST最大切换频率:120 kHz
技术:BICMOS温度等级:INDUSTRIAL
端子面层:Nickel/Palladium/Gold (Ni/Pd/Au)端子形式:GULL WING
端子节距:1.27 mm端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIED宽度:7.5 mm
Base Number Matches:1

UCC28503DW 数据手册

 浏览型号UCC28503DW的Datasheet PDF文件第2页浏览型号UCC28503DW的Datasheet PDF文件第3页浏览型号UCC28503DW的Datasheet PDF文件第4页浏览型号UCC28503DW的Datasheet PDF文件第5页浏览型号UCC28503DW的Datasheet PDF文件第6页浏览型号UCC28503DW的Datasheet PDF文件第7页 
ꢀꢁꢁ ꢂ ꢃꢄ ꢅ ꢅ ꢆ ꢀꢁꢁ ꢂ ꢃꢄ ꢅ ꢇ ꢆ ꢀꢁꢁ ꢂ ꢃꢄ ꢅ ꢂ ꢆ ꢀꢁ ꢁꢂ ꢃꢄ ꢅꢈ  
ꢀꢁꢁ ꢈ ꢃꢄ ꢅ ꢅ ꢆ ꢀꢁꢁ ꢈ ꢃꢄ ꢅ ꢇ ꢆ ꢀꢁꢁ ꢈ ꢃꢄ ꢅ ꢂ ꢆ ꢀꢁ ꢁꢈ ꢃꢄ ꢅꢈ  
SLUS419C − AUGUST 1999 − REVISED NOVEMBER 2001  
ꢔꢕ  
used to keep input power constant with varying input  
voltage. Generation of V is accomplished using I in  
conjunction with an external single-pole filter. This not  
only reduces external parts count, but also avoids the  
use of high-voltage components, offering a lower-cost  
solution. The multiplier then divides the line current by  
FEATURES  
FF  
AC  
D
D
Combines PFC and Downstream Converter  
Controls  
Controls Boost Preregulator to Near-Unity  
Power Factor  
the square of V  
.
D
D
D
D
D
Accurate Power Limiting  
FF  
Improved Feedforward Line Regulation  
The UCC2850x PFC section incorporates a low  
offset-voltage amplifier with 7.5-V reference,  
highly-linear multiplier capable of a wide current range,  
a high-bandwidth, low offset-current amplifier, with a  
a
Peak Current-Mode Control in Second Stage  
Programmable Oscillator  
Leading-Edge/Trailing-Edge Modulation for  
Reduced Output Ripple  
novel  
noise-attenuation  
configuration,  
PWM  
comparator and latch, and a high-current output driver.  
Additional PFC features include over-voltage  
protection, zero-power detection to turn off the output  
when VAOUT is below 0.33 V and peak current and  
power limiting.  
D
Low Start-up Supply Current  
D
Synchronized Second Stage Start-Up, with  
Programmable Soft-start  
D
Programmable Second Stage Shutdown  
The dc-to-dc section relies on an error signal generated  
on the secondary-side and processes it by performing  
peak current mode control. The dc-to-dc section also  
features current limiting, a controlled soft-start, preset  
operating range with selectable options, and 50%  
maximum duty cycle.  
DESCRIPTION  
The UCC2850x family provides all of the control  
functions necessary for an active power-factor-  
corrected preregulator and a second-stage dc-to- dc  
converter. The controller achieves near-unity power  
factor by shaping the ac input line current waveform to  
correspond to the ac input-line voltage using average  
current-mode control. The dc-to-dc converter uses  
peak current-mode control to perform the step-down  
power conversion.  
The UCC28500 and UCC28502 have a wide UVLO  
threshold (16.5 V/10 V) for bootstrap bias supply  
operation. The UCC28501 and UCC28503 are  
designed with a narrow UVLO range (10.5 V/10 V) more  
suitable for fixed bias operation. The UCC28500 and  
UCC28501 have a narrow UVLO threshold for PWM  
stage (to allow operation down to 75% of nominal bulk  
voltage), while the UCC28502 and UCC38503 are  
configured for a much wider operation range for the  
PWM stage (down to 50% of bulk nominal voltage).  
The PFC stage is leading-edge modulated while the  
second stage is trailing-edge synchronized to allow for  
minimum overlap between the boost and PWM  
switches. This reduces ripple current in the bulk-output  
capacitor.In order to operate with over three-to-one  
Available in 20-pin N and DW packages.  
range of input-line voltages, a line feedforward (V ) is  
FF  
ꢕꢤ  
Copyright 2001, Texas Instruments Incorporated  
ꢠ ꢤ ꢡ ꢠꢊ ꢚꢮ ꢜꢛ ꢟ ꢧꢧ ꢥꢟ ꢝ ꢟ ꢞ ꢤ ꢠ ꢤ ꢝ ꢡ ꢩ  
1
www.ti.com  

UCC28503DW 替代型号

型号 品牌 替代类型 描述 数据表
UCC28503NG4 TI

完全替代

1.2A POWER FACTOR CONTROLLER WITH POST REGULATOR, 120kHz SWITCHING FREQ-MAX, PDIP20, GREEN
UCC28503DWTRG4 TI

完全替代

1.2A POWER FACTOR CONTROLLER WITH POST REGULATOR, 120kHz SWITCHING FREQ-MAX, PDSO20, GREEN
UCC28503N TI

完全替代

BICMOS PFC/PWM COMBINATION CONTROLLER

与UCC28503DW相关器件

型号 品牌 获取价格 描述 数据表
UCC28503DWG4 TI

获取价格

BiCMOS PFC/PWM COMBINATION CONTROLLER
UCC28503DWTR TI

获取价格

BICMOS PFC/PWM COMBINATION CONTROLLER
UCC28503DWTRG4 TI

获取价格

1.2A POWER FACTOR CONTROLLER WITH POST REGULATOR, 120kHz SWITCHING FREQ-MAX, PDSO20, GREEN
UCC28503N TI

获取价格

BICMOS PFC/PWM COMBINATION CONTROLLER
UCC28503NG4 TI

获取价格

1.2A POWER FACTOR CONTROLLER WITH POST REGULATOR, 120kHz SWITCHING FREQ-MAX, PDIP20, GREEN
UCC28510 TI

获取价格

ADVANCED PFC/PWM COMBINATION CONTROLLERS
UCC28510_13 TI

获取价格

ADVANCED PFC/PWM COMBINATION CONTROLLERS
UCC28510-17 TI

获取价格

ADVANCED PFC/PWW COMBINATION CONTROLLER WITH TRAILING-EDGE/TRAILING-EDGE MODULATION
UCC28510DW TI

获取价格

ADVANCED PFC/PWM COMBINATION CONTROLLERS
UCC28510DWG4 TI

获取价格

ADVANCED PFC/PWM COMBINATION CONTROLLERS