TSV-300W Series
LED Drivers
Constant Voltage
Aluminum Housing
Electrical Specifications
Input Voltage Range:
277 - 480 Nom. Vac (249 - 528 V Min/Max)
Frequency:
50/60 Hz Nom. (47-63 Hz Min/Max)
0.90 @ full load, 277V through 480V
Power Factor:
Inrush Current:
Input AC Current:
Maximum Power:
135 Amps max @ 480 Vac, cold start 25ºC
1.4 A max 277Vac, 0.8 A max 480Vac
300W
Output Voltage Tolerance: ± 3%
Line Regulation:
Load Regulation:
Leakage Current:
Typical Efficiency
Turn-on Delay:
Ripple and Noise:
Protection:
± 1% Vac
± 1.5% Output current
0.75 mA 480Vac 50Hz
90-91% at 277Vac
1 S typical
2% Vo
Over-Current (Hiccup mode),
Over-Temperature (Latch mode), Lightning,
and Short Circuit Protection (Hiccup mode)
• Total Power: 300 Watts
• Input Voltage: 277-480 Vac Nom.
• UL Dry & Damp Location Rated
• IP67
• High Power Factor
* UL8750, IEC61347
Environmental Specifications
Minimum Starting Temp: -35ºC
Maximum Case Temp.
Storage Temperature:
Humidity:
83°C
-40ºC to +85ºC
5% to 100%
Convection
Class A
Cooling:
Sound Rating:
MTBF:
250,000 Hours at 480Vac input, 80% load and
25ºC ambient conditions per MIL-HDBK-217F
Lifetime:
Weight:
62,000 Hours @ 480V, 80% load, Tc = 60ºC
3.09 lbs. (1.4 kg)
Constant Voltage - Product Specifications
Output Voltage Output Current Max. Output
Typical
Efficiency
Model Number
(Vdc ±3%)
Range (mA)
0-12.5
Power (W)
300
TSV-300S024ST
TSV-300S028ST
TSV-300S036ST
TSV-300S048ST
24
28
36
48
90%
91%
91%
91%
0-10.7
300
0-8.33
300
0-6.25
300
Safety and EMC Compliance
UL/CUL
CE
UL8750, UL1012, CSA-C22.2 No. 107.1
EN61347-1, EN61347-2-13
EN 55015
Conducted emission Test & Radiated emission Test
EN 61000-3-3 Voltage fluctuations & flicker
FCC Part 15 ANSI C63.4:2009 Class B
EN 61000-4-2 Electrostatic Discharge (ESD): 8 kV air discharge, 4 kV contact discharge
EN 61000-4-3 Radio-Frequency Electromagnetic Field Susceptibility Test-RS
EN 61000-4-4 Electrical Fast Transient / Burst-EFT
EN 61000-4-5 Surge Immunity Test: AC Power Line: line to line 4kV, line to earth 6kV
EN 61000-4-6 Conducted Radio Frequency Disturbances Test-CS
EN 61000-4-8 Power Frequency Magnetic Field Test
E332160
EN 61000-4-11 Voltage Dips
EN 61547
Electromagnetic Immunity Requirements Applies To Lighting Equipment
Note:
LED drivers are designed and intended to operate LED loads only.
Non-LED loading may be outside the specified design limits of our
LED drivers, and therefore cannot be covered by any warranty.
If you desire to use our LED drivers to operate non-LED loads
please contact us to discuss compatibility.
Specifications subject to change without notice.
Rev 8-27-15
Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com