TPS23754
TPS23754-1
TPS23756
www.ti.com
SLVS885D –OCTOBER 2008–REVISED DECEMBER 2009
High Power/High Efficiency PoE Interface and DC/DC Controller
1
FEATURES
The TPS23754/6 supports a number of input voltage
ORing options including highest voltage, external
adapter preference, and PoE preference. These
features allow the designer to determine which power
source will carry the load under all conditions.
2
•
Powers up to 30 W (input) PDs
•
DC/DC Control Optimized for Isolated
Converters
•
•
•
Supports High-efficiency Topologies
Complete PoE Interface
The PoE interface features the new extended
hardware classification necessary for compatibility
with high-power midspan power sourcing equipment
(PSE) per IEEE 802.3at. The detection signature pin
can also be used to force power from the PoE source
off. Classification can be programmed to any of the
defined types with a single resistor.
Enhanced Classification per IEEE 802.3at with
Status Flag
•
•
Adapter ORing Support
Programmable Frequency with
Synchronization
•
•
•
Robust 100 V, 0.5 Ω Hotswap MOSFET
–40°C to 125°C Junction Temperature Range
Industry Standard PowerPAD™ TSSOP-20
The dc/dc controller features two complementary gate
drivers with programmable dead time. This simplifies
design of active-clamp forward converters or
optimized gate drive for highly-efficient flyback
topologies. The second gate driver may be disabled if
desired for single MOSFET topologies. The controller
also features internal softstart, bootstrap startup
source, current-mode compensation, and a 78%
APPLICATIONS
•
•
•
•
•
IEEE 802.3at Compliant Devices
Video and VoIP Telephones
RFID Readers
Multiband Access Points
Security Cameras
maximum duty cycle.
A
programmable and
synchronizable oscillator allows design optimization
for efficiency and eases use of the controller to
upgrade existing power supply designs. Accurate
programmable blanking, with
simplifies the usual current-sense filter design
trade-offs.
a
default period,
DESCRIPTION
The TPS23754/6 is a combined Power over Ethernet
(PoE) powered device (PD) interface and
current-mode dc/dc controller optimized specifically
for isolated converters. The PoE interface supports
the IEEE 802.3at standard.
The TPS23754 has a 15 V converter startup while the
TPS23756 has
a 9 V converter startup. The
TPS23754-1 replaces the PPD pin with a no-connect
for increased pin spacing.
CIO
T1
VOUT
CIN
LOUT
M4
RT2P-OUT
T2P
DVC1
DEN
CLS
RT2P
VC
COUT
VT2P-OUT
LVC
M3
N/C OR PPD
PAD
DVC2
Type 2 PSE
Indicator
M1
VB
GATE
CS
VSS
CC
VB
RCTL
APD
CTL
FRS
ROB
CIZ
M2
CCTL
DA
GAT2
CCL
RAPD1
DCL
TLV431
RDT
Optional
Interface
Figure 1. High Efficiency Converter Using TPS23754
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
2
PowerPAD is a trademark of Texas Instruments.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of the Texas
Instruments standard warranty. Production processing does not
necessarily include testing of all parameters.
Copyright © 2008–2009, Texas Instruments Incorporated