TPL910 Series
1-A Output, High-PSRR, Low-Noise LDO Regulator
Electrical Characteristics
TJ = –40°C to +125°C (typical value at TJ = +25°C), VIN = VOUT(NOM) + 0.5 V or 2.2 V, whichever is greater; VEN = 2.2 V, IOUT = 1 mA, CIN = 10 µF, COUT
= 47 µF, CNR = 10 nF, CFF = open, unless otherwise noted.
PARAMETER
TEST CONDITIONS
MIN
TYP
MAX
UNIT
Supply Input Voltage and Current
VIN
Input supply voltage range (1)
Input supply UVLO
Hysteresis
2.2
6.5
2.1
V
VIN rising, RL = 1 kΩ
1.3
200
15
V
UVLO
mV
mA
mA
µA
VIN = 6.5 V, IOUT = 1 mA
VIN = 6.5 V, IOUT = 1 A
VIN = 6.5 V, VEN = Low
30
30
25
IGND
GND pin current
Shutdown current
15
ISD
Device Enable
10
VIH(EN)
VIL(EN)
IEN
EN pin high-level input voltage
Device enable
1.2
0
6.5
0.4
1
V
V
EN pin low-level input voltage
EN pin current
Device disable
VIN = 6.5 V, VEN = 0 V to 6.5 V
0.1
µA
Regulated Output Voltage and Current
VFB
IFB
Feedback voltage
0.79
0.8
0.1
0.8
7.2
0.81
1
V
µA
V
FB pin leakage current
NR/SS pin voltage
VIN = 6.5 V, stress VFB = 0.8V
VNR
INR
NR/SS pin charging current
VIN = 6.5 V, VNR = GND
9
µA
VIN = VOUT(NOM) + 0.5 V or 2.5 V to 6 V, VOUT = 0.8 V
to 5.2 V, IOUT = 100 mA to 500 mA
VIN = VOUT(NOM) + 0.5 V or 2.2 V to 6.5 V, VOUT = 0.8
V to 5.2 V, IOUT = 100 mA to 1 A
–2%
–3%
2%
VOUT
Output accuracy (2)
3%
VIN = VOUT(NOM) + 0.5 V or 2.2 V to 6.5 V, IOUT = 100
mA
Line regulation
Load regulation
0.03
0.07
mV/V
mV/A
mV
ΔVOUT
IOUT = 100 mA to 1 A
VIN = VOUT(NOM) + 0.5 V or 2.2 V to 6.5 V, IOUT = 500
mA, VFB = GND or VSNS = GND
250
350
500
VIN = VOUT(NOM) + 0.5 V or 2.2 V to 6.5 V, IOUT = 750
mA, VFB = GND or VSNS = GND
VDO
Dropout voltage (1)
mV
VIN = VOUT(NOM) + 0.5 V or 2.2 V to 6.5 V, IOUT = 1 A,
VFB = GND or VSNS = GND
mV
A
ILIM
Output current limit
Start-up time
VOUT forced at 0.9 × VOUT(NOM), VIN ≥ 3.3 V
VOUT(NOM) = 3.3 V, VOUT = 0% to 90% VOUT(NOM), RL =
3.3 kΩ, COUT = 10 μF, CNR = 100 nF
1.1.
1.4
13
tSTR
ms
(1) Minimum VIN = VOUT(NOM) + VDO or 2.2 V, whichever is greater.
(2) Resistor tolerance is not included. Output accuracy is not tested at this condition: VOUT = 0.8 V, 4.5V ≤ VIN ≤ 6.5 V, and 750 mA ≤ IOUT ≤ 1 A, because
the power dissipation is out of package limitation.
www.3peak.com
Rev.A.1
7 / 18