THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
HTTP://WWW.CONWIN.COM
P R O D UC T D ATA S H E E T
CRYSTAL CONTROLLED OSCILLATORS
CW 0701
TFLD546E
40.00M
SURFACE MOUNT 3.3V HCMOS TCXO
TFLD546E
ABSOLUTE MAXIMUM RATINGS
PARAMETER
TABLE 1.0
NOTE
UNITS
MINIMUM NOMINAL MAXIMUM
UNITS
°C
Storage Temperature
-40
-
-
85
6
Supply Voltage
(Vcc)
-0.6
Vdc
DESCRIPTION
OPERATING SPECIFICATIONS
PARAMETER
TABLE 2.0
NOTE
MINIMUM NOMINAL MAXIMUM
UNITS
MHz
The Connor-Winfield TFLD546E
is a Surface Mount Temperature
Compensated Crystal Oscillator
(TCXO). Operating at 3.3Vdc,
the TFLD546E will maintain
±4.6ppm frequency tolerance
over 20 years. The TFLD546E is
offered in a surface mount
package for automated
Frequency Range
(Fo)
12.80
-
-
156.25
Frequency Tolerance
-4.6
4.6
ppm
1
Operating Temperature Range
Supply Voltage
0
-
70
°C
(Vcc)
(Icc)
3.135
3.3
9
3.465
Vdc
Supply Current
-
-
-
-
-
-
-
-
25
5
1
-
mA
Jitter (BW=10Hz to 20MHz)
Jitter (BW=12kHz to 20MHz)
SSB Phase Noise at 10Hz offset
SSB Phase Noise at 100Hz offset
SSB Phase Noise at 1KHz offset
SSB Phase Noise at 10KHz offset
SSB Phase Noise at 100KHz offset
-
ps rms
ps rms
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
-
-60
-90
-120
-135
-145
-
-
assembly.
-
-
INPUT CHARACTERISTICS
Enable Voltage (High)
TABLE 3.0
(Vih)
(Vil)
> 70% Vdd
-
-
-
-
Vdc
Vdc
2
Disable Voltage (Low)
< 30% Vdd
FEATURES
HCMOS OUTPUT CHARACTERISTICS
PARAMETER
TABLE 4.0
NOTE
MINIMUM NOMINAL MAXIMUM
UNITS
pF
3.3V OPERATION
LOAD
-
2.0
-
-
-
-
15
-
Voltage
Current
(High)
(Low)
(High)
(Low)
(Voh)
(Vol)
(Ioh)
(Ioh)
Vdc
Vdc
mA
mA
%
OVERALL FREQUENCY TOLERANCE:
±4.6ppm OVER 20 YEARS.
0.4
-
-
-
-4
-
4
TEMPERATURE RANGE: 0 to 70°C
LOW JITTER <1pS RMS
Duty Cycle at 50% of Vcc
45
50
3
55
5
Rise / Fall Time 10% to 90%
nS
TRI-STATE ENABLE/DISABLE FUNCTION
SURFACE MOUNT PACKAGE
TAPEAND REEL PACKAGING
PACKAGE CHARACTERISTICS
TABLE 4.0
Package
Non-hermetic package consisting of an FR4 substrate with grounded metal
cover.
PROCESS RECOMMENDATIONS
Solder Reflow
TABLE 6.0
The component solder used internal to this device has a m elting point of
221°C. The peak temperature inside the device should be less than or
equal to 220°C for a maximum of 10 seconds
Wash
Ultrasonic cleaning is not recommended.
ORDERING INFORMATION
Note:
TFLD546E - 40.00MHz
1) Inclusive of calibration, frequency vs. temperature stability, supply voltage change, load change,
shock and vibration, 20 years aging.
2) Oscillator output is enabled with no connection on pad 1. Output is at high impedance when
disabled.
TCXO
CENTER
FREQUENCY
SERIES
Specifications subject to change without notice.
11/10/04
Tx110
1
2
02
REV:
Copyright 2001 Connor-Winfield all rights reserved.
DATASHEET #:
PAGE
OF
DATE:
a