5秒后页面跳转
SS2413LUA PDF预览

SS2413LUA

更新时间: 2022-02-26 10:29:16
品牌 Logo 应用领域
SECELECTRONICS /
页数 文件大小 规格书
9页 368K
描述
Hall Latch - High Sensitivity

SS2413LUA 数据手册

 浏览型号SS2413LUA的Datasheet PDF文件第3页浏览型号SS2413LUA的Datasheet PDF文件第4页浏览型号SS2413LUA的Datasheet PDF文件第5页浏览型号SS2413LUA的Datasheet PDF文件第7页浏览型号SS2413LUA的Datasheet PDF文件第8页浏览型号SS2413LUA的Datasheet PDF文件第9页 
SS2413  
Hall Latch - High Sensitivity  
Application Information  
It is strongly recommended that an external bypass capacitor be connected (in close proximity to the Hall sensor)  
between the supply(VDD Pin) and ground(GND Pin) of the device to reduce both external noise and noise gener-  
ated by the chopper stabilization technique. As is shown in the two figures in next page, a 0.1μF capacitor is  
typical.  
For reverse voltage protection, it is recommended to connect a resistor or a diode in series with the V  
When using a resistor, three points are important:  
pin.  
DD  
- the resistor has to limit the reverse current to 50mA maximum (V  
/ R1 50mA)  
CC  
- the resulting device supply voltage VDD has to be higher than VDD min (VDD = VCC – R1*IDD  
- the resistor has to withstand the power dissipated in reverse voltage condition (P = VCC  
)
2/R1)  
D
When using a diode, a reverse current cannot flow and the voltage drop is almost constant (0.7V).  
Therefore, a 100/0.25W resistor for 5V application and a diode for higher supply voltage are recommended.  
Both solutions provide the required reverse voltage protection.  
When a weak power supply is used or when the device is intended to be used in noisy environment, it is  
recommended that figure 13.3 from the Application Information section is used.  
The low-pass filter formed by R1 and C1 and the zener diode Z1 bypass the disturbances or voltage spikes occur-  
ring on the device supply voltage VDD. The diode D1 provides additional reverse voltage protection.  
Automotive and Severe Environment  
Protection Circuit  
Typical Three-Wire Application Circuit  
R1:100  
VDD  
VDD  
C1  
R2  
C2  
C1  
R2  
C2  
D1  
Z1  
OUT  
OUT  
SS2413  
SS2413  
GND  
GND  
6
V3.10 Jan 1, 2014  

与SS2413LUA相关器件

型号 品牌 描述 获取价格 数据表
SS241575ADAS SYSTEMSENSOR Synchronized Strobes with SyncCircuit

获取价格

SS2415ADAS SYSTEMSENSOR Synchronized Strobes with SyncCircuit

获取价格

SS2432G SSC Dual Adjustable Precision Shunt Regulator

获取价格

SS245F HDSEMI SMAF Plastic-Encapsulate Diodes

获取价格

SS245F BL Galaxy Electrical 2A,45V, Surface Mount Schottky Barrier Rectifiers

获取价格

SS247 SECELECTRONICS CMOS Omnipolar High Sensitivity Micropower Hall Switch

获取价格