5秒后页面跳转
SN65C3221EDBG4 PDF预览

SN65C3221EDBG4

更新时间: 2024-11-18 15:51:59
品牌 Logo 应用领域
德州仪器 - TI 驱动光电二极管接口集成电路驱动器
页数 文件大小 规格书
20页 578K
描述
LINE TRANSCEIVER, PDSO16, GREEN, PLASTIC, SSOP-16

SN65C3221EDBG4 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Obsolete零件包装代码:SOIC
包装说明:SSOP, SSOP16,.3针数:16
Reach Compliance Code:compliantECCN代码:EAR99
HTS代码:8542.39.00.01风险等级:5.09
其他特性:ALSO OPERATES AT 5V SUPPLY差分输出:NO
驱动器位数:1高电平输入电流最大值:0.000001 A
输入特性:SCHMITT TRIGGER接口集成电路类型:LINE TRANSCEIVER
接口标准:EIA-232JESD-30 代码:R-PDSO-G16
JESD-609代码:e4长度:6.2 mm
湿度敏感等级:1功能数量:1
端子数量:16最高工作温度:85 °C
最低工作温度:-40 °C最小输出摆幅:10 V
最大输出低电流:0.0016 A封装主体材料:PLASTIC/EPOXY
封装代码:SSOP封装等效代码:SSOP16,.3
封装形状:RECTANGULAR封装形式:SMALL OUTLINE, SHRINK PITCH
峰值回流温度(摄氏度):260电源:3.3/5 V
认证状态:Not Qualified最大接收延迟:
接收器位数:1座面最大高度:2 mm
子类别:Line Driver or Receivers最大压摆率:1 mA
最大供电电压:3.6 V最小供电电压:3 V
标称供电电压:3.3 V表面贴装:YES
温度等级:INDUSTRIAL端子面层:Nickel/Palladium/Gold (Ni/Pd/Au)
端子形式:GULL WING端子节距:0.65 mm
端子位置:DUAL处于峰值回流温度下的最长时间:NOT SPECIFIED
宽度:5.3 mmBase Number Matches:1

SN65C3221EDBG4 数据手册

 浏览型号SN65C3221EDBG4的Datasheet PDF文件第2页浏览型号SN65C3221EDBG4的Datasheet PDF文件第3页浏览型号SN65C3221EDBG4的Datasheet PDF文件第4页浏览型号SN65C3221EDBG4的Datasheet PDF文件第5页浏览型号SN65C3221EDBG4的Datasheet PDF文件第6页浏览型号SN65C3221EDBG4的Datasheet PDF文件第7页 
SN65C3221E, SN75C3221E  
www.ti.com .................................................................................................................................................. SLLS694BNOVEMBER 2005REVISED APRIL 2009  
3-V TO 5.5-V SINGLE-CHANNEL RS-232 1-Mbit/s LINE DRIVER/RECEIVER  
WITH ±15-kV IEC ESD PROTECTION  
1
FEATURES  
DB OR PW PACKAGE  
ESD Protection for RS-232 Pins  
(TOP VIEW)  
±15-kV Human-Body Model (HBM)  
EN  
C1+  
V+  
FORCEOFF  
VCC  
1
2
3
4
5
6
7
8
16  
15  
14  
13  
12  
11  
10  
9
±8-kV IEC 61000-4-2 Contact Discharge  
±15-kV IEC 61000-4-2 Air-Gap Discharge  
GND  
Operate With 3-V to 5.5-V VCC Supply  
Operate up to 1 Mbit/s  
C1−  
C2+  
C2−  
V−  
DOUT  
FORCEON  
DIN  
Low Standby Current . . . 1 µA Typ  
External Capacitors . . . 4 × 0.1 µF  
Accepts 5-V Logic Input With 3.3-V Supply  
INVALID  
ROUT  
RIN  
RS-232 Bus-Pin ESD Protection Exceeds ±15  
kV Using Human-Body Model (HBM)  
Auto-Powerdown Feature Automatically  
Disables Drivers for Power Savings  
APPLICATIONS  
Battery-Powered, Hand-Held, and Portable  
Equipment  
PDAs and Palmtop PCs  
Notebooks, Sub-Notebooks, and Laptops  
Digital Cameras  
Mobile Phones and Wireless Devices  
DESCRIPTION/ORDERING INFORMATION  
The SN65C3221E and SN75C3221E consist of one line driver, one line receiver, and a dual charge-pump circuit  
with ±15-kV IEC ESD protection pin to pin (serial-port connection pins, including GND). These devices provide  
the electrical interface between an asynchronous communication controller and the serial-port connector. The  
charge pump and four small external capacitors allow operation from a single 3-V to 5.5-V supply. These devices  
operate at data signaling rates up to 1 Mbit/s and a driver output slew rate of 24 V/µs to 150 V/µs.  
Flexible control options for power management are available when the serial port is inactive. The  
auto-powerdown feature functions when FORCEON is low and FORCEOFF is high. During this mode of  
operation, if the devices do not sense a valid RS-232 signal on the receiver input, the driver output is disabled. If  
FORCEOFF is set low and EN is high, both the driver and receiver are shut off, and the supply current is  
reduced to 1 µA. Disconnecting the serial port or turning off the peripheral drivers causes the auto-powerdown  
condition to occur. Auto-powerdown can be disabled when FORCEON and FORCEOFF are high. With  
auto-powerdown enabled, the device is activated automatically when a valid signal is applied to the receiver  
input. The INVALID output notifies the user if an RS-232 signal is present at the receiver input. INVALID is high  
(valid data) if the receiver input voltage is greater than 2.7 V or less than –2.7 V, or has been between –0.3 V  
and 0.3 V for less than 30 µs. INVALID is low (invalid data) if the receiver input voltage is between –0.3 V and  
0.3 V for more than 30 µs. See Figure 5 for receiver input levels.  
1
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas  
Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.  
PRODUCTION DATA information is current as of publication date.  
Copyright © 2005–2009, Texas Instruments Incorporated  
Products conform to specifications per the terms of the Texas  
Instruments standard warranty. Production processing does not  
necessarily include testing of all parameters.  

与SN65C3221EDBG4相关器件

型号 品牌 获取价格 描述 数据表
SN65C3221EDBR TI

获取价格

3-V TO 5.5-V SINGLE-CHANNEL RS-232 1-Mbit/s L
SN65C3221EDBRG4 TI

获取价格

3-V To 5.5-V Single Channel RS-232 1 Mbit/s Line Driver/Receiver 16-SSOP -40 to 85
SN65C3221EPW TI

获取价格

3-V TO 5.5-V SINGLE-CHANNEL RS-232 1-Mbit/s L
SN65C3221EPWE4 TI

获取价格

3-V TO 5.5-V SINGLE-CHANNEL RS-232 1-Mbit/s L
SN65C3221EPWR TI

获取价格

3-V TO 5.5-V SINGLE-CHANNEL RS-232 1-Mbit/s L
SN65C3221EPWRE4 TI

获取价格

3-V TO 5.5-V SINGLE-CHANNEL RS-232 1-Mbit/s L
SN65C3221EPWRG4 TI

获取价格

LINE TRANSCEIVER, PDSO16, GREEN, PLASTIC, TSSOP-16
SN65C3221IDBRQ TI

获取价格

3-V TO 5.5V SINGLE-CHANNEL RS-232 COMPATIBLE LINE DRIVER/RECEIVER
SN65C3221IPWRG4Q1 TI

获取价格

具有 +/-15kV ESD 保护的 3V 至 5.5V 单通道 1Mbps RS-232
SN65C3221IPWRQ1 TI

获取价格

3-V TO 5.5V SINGLE-CHANNEL RS-232 COMPATIBLE LINE DRIVER/RECEIVER