SL10 Series Slot Sensor
Datasheet
Self-Contained Opposed-Mode Sensor Pair
•
•
•
•
•
An easy-to-use self-contained opposed-mode sensor pair in a rugged U-shaped housing
Easy and economical to mount
Molded-in beam guides simplify mounting and beam placement
10 mm slot width for a wide variety of sensing applications
Applications include label detection, hole detection, gear tooth detection, edge guiding, parts
detection and counting
•
•
•
•
•
•
•
•
2 mm effective beam
10 to 30V dc operation
Bipolar PNP/NPN outputs
Visible red beam
Choose 1 millisecond or 300 microsecond response
4-turn potentiometer sensitivity adjustment
Dark or light operate
Choose integral, unterminated cable or QD models
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to serious injury or death. This device
does not include the self-checking redundant circuitry necessary to allow its use in personnel safety applications. A sensor
failure or malfunction can cause either an energized or de-energized sensor output condition.
Models
1
Models
Sensing Beam
Slot Width
Cable
Supply
Voltage
Output Type
Response
Repeatability
SL10VB6V
2 m (6.5ft) 5-wire cable
5-Pin Euro-style QD
2 m (6.5ft) 5-wire cable
5-Pin Euro-style QD
1 ms
250 µs
75 µs
SL10VB6VQ
SL10VB6VY
SL10VB6VYQ
10 V dc to 30 Bipolar NPN
V dc and PNP
Visible red, 680 nm
10 mm (0.4 in)
300 µs
Overview
The SL10 Series Slot Sensor (sometimes called a “Fork Sensor”)
comprises an opposed-mode emitter and its receiver inside a single
convenient housing.
Opposed-mode sensing is very reliable, and the single self-contained
housing provides easy installation, with no sensor alignment required. In
addition, the molded-in arrow on the emitter portion of the housing and
the slotted design on the receiver portion of the housing show at a
glance the position of the beam, simplifying installation placement.
Emitter
Signal LED
Power ON LED
Receiver (Beam Aligns at Groove)
Sensitivity
Adjustment
Figure 1. Features
1
To order the 9 m (30 ft) PVC cable model, add the suffix "W/30" to the cabled model number. For example, Models with a quick disconnect require a mating
cordset.
Original Document
58341 Rev. D
23 February 2018
58341