SGM25006
Power Distribution Switch with
Precision Adjustable Current Limit
GENERAL DESCRIPTION
FEATURES
The SGM25006 is a single channel power distribution
switch. The switch operates from a wide range of 2.5V
to 6.5V supply voltage, and is controlled by the nEN/EN
pin. The rise time and fall time of the device are
controlled internally to avoid inrush current.
● Input Voltage Range: 2.5V to 6.5V
● For USB Current Limit Requirements
● Adjustable Current Limit: 500mA to 5A
● ±5% Current Limit Accuracy at 4.5A
● Fast Over-Current Response: 3.5μs (TYP)
● On-Resistance: 20mΩ (TYP)
● Supply Current: 115μA (TYP)
● Built-in Soft-Start
An integrated charge pump biases the N-MOSFET
switch in order to achieve a low switch RDSON. This
device provides the adjustable current limit threshold
between 500mA and 5A through the RILIM. If the load
current is higher than the current limit threshold, the
device will limit the output current to a safe level and
enter into constant-current mode. Fault conditions such
as over-current and over-temperature are indicated by
the nFAULT pin.
● Enable Pin Options
SGM25006A: Active-High
SGM25006B: Active-Low
● 15kV (1) and 8kV System-Level ESD Capable
APPLICATIONS
The SGM25006 is available in a Green TDFN-3×3-8FL
package.
USB Ports and Hubs
Digital TVs
IP Camera
Server or PC
TYPICAL APPLICATION
2. 5V to 6.5V
IN
VOUT
OUT
CIN
*
CLOAD
RnFAULT
100kΩ
0. 1µF *
SGM25006A
nFAULT Signal
nFAULT
ILIM
RILI M
Control Signal
EN
GND
NOTE: *. In the case of short-circuit, the lead is relatively long, or the input capacitor parasitic inductance is relatively large, the
resonance may cause VIN overshoot or burning die, it is recommended that the input capacitance is above 10μF, the output
capacitance is above 1μF.
Figure 1. Typical Application Circuit
NOTE: 1. CIN = 1μF.
SG Micro Corp
NOVEMBER 2023 – REV. A
www.sg-micro.com