SF1071 71 MHz SAW Filter
·
·
·
·
Designed for GSM Receiver IF Applications
Simple External Impedance Matching
Hermetic Metal DIP
Unbalanced Input and Output
Characteristic
Nominal Center Frequency
Passband
Sym
fc
IL
Min
Typ
71.000
8
Max
Units Notes
MHz
dB
1
Insertion Loss at fc
9.5
±200
350
3 dB Passband BW3
kHz
nsP-P
dB
1, 2, 3
±100
Group Delay Variation over fc ±100 kHz GDV
fc-1.2 to fc-0.4 and fc+0.4 to fc+1.2 MHz
fc-1.6 to fc-1.2 and fc+1.2 to fc+1.6 MHz
fc-18.0 to fc-1.6 and fc+1.6 to fc+8.0 MHz
1 to 63 and 79 to 150 MHz
Rejection
30
35
40
45
-10
Operating Temperature Range
TA
+85
1
°C
External L-C
DIP14-6 20.2 x 12.6 mm Nominal Footprint
RFM SF1071 YYWW
Impedance Matching to 50 W unbalanced
Case Style
Lid Symbolization ( YY = year, WW = week)
Absolute Maximum Ratings
Rating
Maximum Incident Power in Passband
Max. DC voltage between any 2 terminals
Storage Temperature Range
Max Soldering Profile
Electrical Connections (See note 3)
Value
+15
30
Units
dBm
VDC
°C
Connection Terminals
Port 1 Hot
Port 2 Hot
1
8
-40 to +85
Case Ground All others
265°C for 10 s
Notes:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified
demonstration board with impedance matching to 50 W and measured with 50 W network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent
on PCB layout and external impedance matching design. See Application Note No. 42 for details. All “NC” or “no connection”
terminals should be grounded.
4. “LRIP” or “L” after the part number indicates “low rate initial production” and “ENG” or “E” indicates “engineering prototypes.”
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may
vary between Port 1 and Port 2, so that the filter must always be installed in one direction per the circuit design.
7. US and international patents may apply.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
9. ã Copyright 1999, RF Monolithics Inc.
10. Electrostatic Sensitive Device. Observe precautions for handling.
RF Monolithics, Inc.
4347 Sigma Road
Dallas, Texas 75244
USA
Phone: +1(972)233-2903
Fax: +1(972)387-8148
e-mail: info@rfm.com
European Sales Office
44 1963 251383
44 1963 25151 0
Home page: www.rfm.com
SF1071 7/22/1999 R