SF1080A
•
•
•
•
•
Designed for CATV Applications (Pilot Tone)
Tightly Controlled Insertion Loss
9.1 x 7.1 mm Surface-Mount Case
Unbalanced Input and Output
499.25 MHz
SAW Filter
Complies with Directive 2002/95/EC (RoHS)
Pb
Absolute Maximum Ratings
Rating
Value
+10
Units
dBm
VDC
°C
Maximum Incident Power in Passband
Max. DC voltage between any 2 terminals
Storage Temperature Range
30
-54 to +85
Suitable for lead-free soldering - Max Soldering Profile
260°C for 30 s
SM9171-10
Electrical Characteristics
Characteristic
Sym
Notes
Min
Typ
Max
Units
f
1
499.250
Nominal Center Frequency
MHz
dB
C
Passband
Insertion Loss at fc
0.5 dB Passband
6.0
7.5
9.0
IL
BW
1, 2
±100
±800
0.5
kHz
3 dB Passband
Amplitude Ripple over fc ±100 kHz
fc-200 to fc-3.0 and fc+3.0 to fc+200 MHz
Ultimate
BW
±970
3
dB
0.5
P-P
1, 2, 3
1
Rejection
35
40
dB
°C
T
Operating Temperature Range
+75
-25
A
Impedance Matching to 50 W unbalanced
Case Style
External L-C
SM9171-10 9.1 x 7.1 mm Nominal Footprint
RFM SF1080A XX
Lid Symbolization (XX = 2 character date code)
Electrical Connections
Connection
Port 1 Hot
Terminals
10
Port 1 Gnd Return
Port 2 Hot
1
5
6
Port 2 Gnd Return
Case Ground
All others
Notes:
1. Unless noted otherwise, all specitication apply over the operating temperature range with filter soldered to the specified demonstration board with
impedanced matching to 50 W network analyzer.
2. Unless noted otherwise, all frequency specitications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout
and external impedance matching design. See Application Note No. 42 for details.
4. “LRIP” or “L” after the part number indicates “low rate initial production” and “ENG” or “E” indicates “engineering prototypes.”
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port
1 and Port 2, so that the filter must always be installed in one direction per the circuit design.
7. US and international patents may apply.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
9. Electrostatic Sensitive Device. Observe precautions for handling.
RF Monolithics, Inc.
RFM Europe
Phone: (972) 233-2903
Phone: 44 1963 251383
Fax: (972) 387-9148
Fax: 44 1963 251510
E-mail: info@rfm.com
http://www.rfm.com
SF1080A-112904
Page 1 of 3
©2001 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc.