Photoelectrics
Amplifier, µ-Processor Controlled
Type S1430 UAP, 3 Inputs/3 Transistor Outputs
• µ-Processor controlled
• Amplifier unit for 3 sets of photoelectrics
• 3 independent outputs
• NPN/PNP both NO or NC selectable
• Self-diagnostic functions
• Alignment failure indication
• Multivoltage 12 to 30 VAC/DC
• Modulated and synchronized light
• Adjustable sensitivity for each channel
• LED indications: supply, outputs, signal quality
• 11-pin plug-in housing
• For 115 or 230 VAC use power supplys from SS120-series
Product Description
Ordering Key
S14 30 UAP 912
µ-Processor controlled ampli- diagnostics for system test. Type
fier for 3 sets of photoelec- Protected against short-cir- Special function
tric sensors, type MOFTR, cuits, reverse wiring or cross Output type
MKFTR, MIFTR or MHFTR. talk from adjacent photoelec- Power supply
Utilising an 11-pin circular trics. Multi-voltage power
plug for easy connection, supply. Sensitivity is indivi-
outputs freely selectable for dually adjustable for each
NPN/PNP or NO/NC. Self- set of photoelectrics.
Type Selection
Plug type
Ordering no.
Supply: 12 - 30 VAC/DC
Circular, 11 pins
S 1430 UAP 912
Specifications
Rated operational voltage (UB)
Supply to photoelectric switch
pins 2 & 10
DC
AC
10.8 to 33 VDC
10.8 to 33 VAC, 45 to 65 Hz
(cont.)
Receiver
Rx1: Pin 4
Rx2: Pin 7
Rx3: Pin 8
Shield: Pin 5 (common)
5 VDC
10 mA
470 Ω
Rated operational power
AC supply
DC supply
4 VA
3 W
Supply voltage (open loop)
Short-circuit current
Input resistance
Power ON delay (tv)
Output function
< 300 ms
NPN and PNP switching
Make and break function
DIP-Switch selectable
Sensitivity
(% of Sn)
• 2 ranges,
DIP-Switch selectable
- low sensitivity (25%)
- high sensitivity (100%)
• Sensitivity adjustment
with 270°:
Turn knob on CH 1, 2, 3
• Maximum range indi-
cated on photoelectric
switch data sheet in high
sensitivity range only
• Operation within low
sensitivity range, increa-
ses ambient light and
crosstalk immunity
Output current
Continuous (Ie)
Short-time (I)
100 mA per output
100 mA max.
Min. load current (Im)
OFF-state current (Ir)
Voltage drop (Ud)
0.5 mA
Max. 100 µA
≤ 3.5 VDC
Note:
Protection, outputs
Reverse polarity, short-circuit,
transients
Supply to photoelectric switch
Emitter
Tx1: Pin 1
Tx2: Pin 9
Tx3: Pin 6
Shield: Pin 11 (common)
7 V square wave
≤ 300 mA short-circuit protected
10 Ω
Operating frequency (f)
Light/dark ratio 1:1
Supply voltage (open loop)
Current
Output resistance
16 Hz
Specifications are subject to change without notice (25.06.99)
1