RT5028
Pin No.
16
Pin Name
SDA
Pin Function
Data input for I2C. Open-drain output, connect a 10kΩ pull-up resistor.
Enable control input for LDO7. Connect a 100kΩ pull-low resistor.
Enable control input for LDO8. Connect a 100kΩ pull-low resistor.
Open-Drain IRQ output node.
17
ENL7
ENL8
IRQ
18
19
20
Reset output.
RESET
21, 34, 56, 57
(Exposed Pad)
Analog ground. The exposed pad must be soldered to a large PCB and
connected to AGND for maximum power dissipation.
AGND
22
23
PWRON
REBOOT
Manual power on. Connect a 100kΩ pull-up resistor.
System power reboot. Connect a 100kΩ pull-low resistor.
MTP write protection pin. Connect a 100kΩ pull-low resistor, logic low is inhibited
and logic high is permit to write.
24
MTP
Select I2C or use EN pin for Bucks and LDOs. Connect a 100kΩ pull-low resistor.
As MASK_GPIO is high, ignore all EN pins.
As MASK_GPIO is low, EN pins and I2C both can control. EN pins priority is
higher than I2C.
25
26
MASK_GPIO
PWRHOLD
Power hold input. Connect a 100kΩ pull-low resistor.
27
28
SADDR
ENB4
I2C slave address. Connect a 100kΩ pull-low resistor.
Enable control input for Buck4. Connect a 100kΩ pull-low resistor.
Output voltage regulation node for Buck4.
29
VOUTB4S
ENB3
30
Enable control input for Buck3. Connect a 100kΩ pull-low resistor.
Internal switch node to output inductor connection for Buck4.
Input power for Buck4.
31
LXB4
32
VINB4
VOUTB3S
LXB3
33
Output voltage regulation node for Buck3.
35, 36
37, 38
39
Internal switch node to output inductor connection for Buck3.
Input power for Buck3.
VINB3
VOUTB2S
ENB2
Output voltage regulation node for Buck2.
40
Enable control input for Buck2. Connect a 100kΩ pull-low resistor.
Internal switch node to output inductor connection for Buck2.
Input power for Buck2.
41, 42
43, 44
45, 46
47, 48
49
LXB2
VINB2
VINB1
LXB1
Input power for Buck1.
Internal switch node to output inductor connection for Buck1.
Enable control input for Buck1. Connect a 100kΩ pull-low resistor.
Output voltage regulation node for Buck1
ENB1
50
VOUTB1S
VDDP
VIN
51
Internal bias regulator voltage. External load on this pin is not allowed.
Input power for analog base.
52
53
ENL1
Enable control input for LDO1. Connect a 100kΩ pull-low resistor.
Enable control input for LDO2. Connect a 100kΩ pull-low resistor.
Enable control input for LDO3. Connect a 100kΩ pull-low resistor.
54
ENL2
55
ENL3
Copyright 2016 Richtek Technology Corporation. All rights reserved.
©
is a registered trademark of Richtek Technology Corporation.
DS5028-02 September 2016
www.richtek.com
3