RH1016M
UltraFast Precision
10ns Comparator
DESCRIPTION
ABSOLUTE MAXIMUM RATINGS
(Note 1)
The RH1016 is an UltraFastTM 10ns comparator that inter-
faces directly to TTL/CMOS logic while operating from
either ±5V or single 5V supplies. Tight offset voltage
specifications and high gain allow the RH1016 to be used
inprecisionapplications.Matchedcomplementaryoutputs
further extend the versatility of this comparator.
Positive Supply Voltage (Note 5).................................7V
Negative Supply Voltage ...........................................–7V
Differential Input Voltage (Note 7).............................±5V
+IN, –IN and LATCH ENABLE Current (Note 7) ....±10mA
Output Current (Continuous) (Note 7) .................±±0mA
Operating Temperature Range................ –55°C to 1±5°C
Storage Temperature Range................... –65°C to 150°C
Lead Temperature (Soldering, 10 sec) .................. 300°C
A unique output stage provides active drive in both direc-
tions for maximum speed into TTL/CMOS logic or passive
loads, yet does not exhibit the large current spikes found
in conventional output stages. This allows the RH1016 to
remain stable with the outputs in the active region which
greatly reduces the problem of output “glitching” when
the input signal is slow moving or is low level.
L, LT, LTC and LTM are registered trademarks of Linear Technology Corporation.
UltraFast is a trademark of Linear Technology Corporation.
All other trademarks are the property of their respective owners.
The RH1016 has a LATCH pin which will retain input data
at the outputs, when held high. Quiescent negative power
supplycurrentisonly3mA.Thisallowsthenegativesupply
pin to be driven from virtually any supply voltage with a
simpleresistivedivider.Deviceperformanceisnotaffected
by variations in negative supply voltage.
The wafer lots are processed to Linear Technology’s in-
house Class S flow to yield circuits usable in stringent
military applications.
BURN-IN CIRCUIT
PACKAGE INFORMATION
V4 MONITOR
TOP VIEW
F1
V4
+
T. P.
V
1
±
3
4
5
10
9
Q OUT
±0Ω
5.11k
+IN
–IN
Q OUT
1
±
3
4
5
10
9
8
GND
T. P.
1k
–
V
7
LATCH ENABLE
NC
T. P.
8
NC
6
5.11k
7
6
W PACKAGE
10-LEAD CERPAC
GND POWER
±0Ω
F±
T. P.
V3
V3 MONITOR
GND MONITOR
RH1016 BURN-IN
NOTES:
1. UNLESS OTHERWISE SPECIFIED, COMPONENT TOLERANCES
SHALL BE PER MILITARY SPECIFICATION.
±. T = 161°C MAXIMUM
J
3. T = 139°C MINIMUM
C
4. T = 100°C MINIMUM
A
BURN-IN VOLTAGES: V4 = 5.5V TO 6V
V3 = –5.5V TO –6V
rh1016fa
1