MODEL: R30PA2
Remote I/O R30 Series
RELATED PRODUCTS
• Interface module
Model: R30NECT1 (firmware version V1.04.10 or higher)
Model: R30NCIE1 (firmware version V1.01.13 or higher)
• Paperless recorder
TOTALIZED PULSE INPUT MODULE
(Pi 2 points, 32 Bits)
Functions & Features
Model: TR30 (firmware version V1.05 or higher)
• PC configurator software (model: R30CFG)
Downloadable at M-System’s web site.
For connecting to PC, use commercially available Mini-B
type USB cable. (provided by user)
• Space-saving remote I/O module of 2 points input pulse
counter
• 32-bit binary data
25 [.98]
GENERAL SPECIFICATIONS
Connection
110
[4.33]
Internal bus: Via the Installation Base (model: R30BS)
Input: M3 separable screw terminal (torque 0.5 N·m)
Internal power: Via the Installation Base (model: R30BS)
Solderless terminal: Refer to the drawing at the end of the
section.
98
[3.86]
Recommended manufacturer: Japan Solderless Terminal
MFG. Co., Ltd., Nichifu Co., Ltd.
mm [inch]
(Solderless terminals with insulation sleeve do not fit.)
Applicable wire size: 0.25 to 0.75 mm
2
MODEL: R30PA2S[1]
Screw terminal: Nickel-plated steel
Isolation: Input or reset input or external power to internal
bus or internal power
ORDERING INFORMATION
• Code number: R30PA2S[1]
Specify a code from below for [1].
(e.g. R30PA2S/Q)
Status indicator LEDs: RUN, ERR
Input status indicator LEDs: Green LED; turns on with input
ON
(Refer to the instruction manual.)
• Specify the specification for option code /Q
(e.g. /C01/SET)
Count reset: by inputting one pulse to the reset input
terminal, or from host PC/PLC
Count preset: settable from host PC/PLC, or with PC
configurator software
NO. OF CHANNELS
2: 2
■Recommended solderless terminal size - M3 (unit: mm)
3 max.
COMMUNICATION MODE
3.2 dia.
S: Single
[1] OPTIONS
Other Options
12 max.
blank: none
/Q: Option other than the above (specify the specification)
SPECIFICATIONS OF OPTION: Q (multiple selections)
COATING (For the detail, refer to M-System's web site.)
/C01: Silicone coating
/C02: Polyurethane coating
/C03: Rubber coating
EX-FACTORY SETTING
/SET: Preset according to the Ordering Information Sheet
(No. ESU-9022)
R30PA2 SPECIFICATIONS
ES-9022 Rev.2 Page 1/5
https://www.m-system.co.jp/