MODEL: R3-PD16A
EX-FACTORY SETTING
Remote I/O R3 Series
/SET: Preset according to the Ordering Information Sheet
(No. ESU-8395)
ONE-SHOT PULSE OUTPUT MODULE
(NPN transistor output, 16 points)
RELATED PRODUCTS
• Interface module (model: R3-Nx)
27.5 [1.08]
Output completion status is compatible with interface
modules model: R3-NC1, -NC3, -NE1, -NM1 and -NDx of
firmware version V2.00 or higher. Other interface modules
are not compatible. So, set I/O Mode as output (SW2-7: ON)
to use it.
130
[5.12]
Note: R3-NL1 and R3-NL2 are not available with this model.
109
[4.29]
GENERAL SPECIFICATIONS
Connection
mm [inch]
Internal bus: Via the Installation Base (model: R3-BSx)
Output: M3 separable screw terminal (torque 0.5 N·m)
Internal power: Via the Installation Base (model: R3-BSx)
Screw terminal: Nickel-plated steel
MODEL: R3-PD16A[1][2]
Isolation: Output to internal bus or internal power
Output mode setting: One-Shot Output Mode, ON/OFF
Control Output Mode, Continuance Output Mode selectable
with DIP switch
ORDERING INFORMATION
• Code number: R3-PD16A[1][2]
Specify a code from below for each of [1] and [2].
(e.g. R3-PD16AW/CE/Q)
Output data length: 16bit, 8bit selectable with DIP switch
(For ON/OFF Control Output Mode only)
I/O mode setting: Output Complete Status ON/OFF is
selectable with DIP switch
• Specify the specification for option code /Q
(e.g. /C01/SET)
NO. OF CHANNELS
16: 16
One-shot ON time setting: 0.1 to 25.6 sec. selectable with
DIP switch
ON/OFF control output setting: Swappable its pair with DIP
switch.
OUTPUT
Output hold function: Setting for communication error with
side DIP SW (available in continuance output mode)
RUN indicator: Bi-color (red/green) LED;
Red when the bus A operates normally;
Green when the bus B operates normally;
Amber when both buses operate normally.
ERR indicator: Bi-color (red/ green) LED;
Green in normal operating conditions;
Red with abnormal configuration.
A: NPN transistor
[1] COMMUNICATION MODE
S: Single
W: Dual
[2] OPTIONS (multiple selections)
Standards & Approvals
blank: Without CE
Output status indicator: Red LED; turns on with the output
ON.
/CE: CE marking
Other Options
blank: none
OUTPUT SPECIFICATIONS
Output: Open collector, 16 points
/Q: Option other than the above (specify the specification)
Isolation: Optical isolator
Common: All 16 points (2 terminals)
Common current: Max. 1.6 A per common
External excitation: 24 V DC ±10 %, approx. 0.02 A with no
load; approx. 1.6 A with max. load
SPECIFICATIONS OF OPTION: Q (multiple selections)
COATING (For the detail, refer to M-System's web site.)
/C01: Silicone coating
/C02: Polyurethane coating
Rated load voltage: 24 V DC ±10 %
/C03: Rubber coating
R3-PD16A SPECIFICATIONS
ES-8397 Rev.6 Page 1/7
https://www.m-system.co.jp/