Radial Lead
CONDUCTIVE POLYMER ALUMINUM SOLID CAPACITORS
New!
@Super low ESR, high temperature resistance and high ripple current capability
@Rated voltage range : 2.5 to 10Vdc
@2000 hours at 105C
@Suitable for DC-DC converters, voltage regulators and decoupling applications
for computer motherboards
?SPECIFICATIONS
Items
Characteristics
Category
Temperature Range
-55 to +105C
Rated Voltage Range 2.5 to 10Vdc
Capacitance Tolerance P20% (M)
(at 20C, 120Hz)
(at 105C)
Surge Voltage
Leakage Current
*Note
Rated voltageB1.15V
I=0.2CV (max.)
Where, I : Leakage current (MA), C : Nominal capacitance (MF), V : Rated voltage (Vdc
)
(at 20C after 2 minutes)
(at 20C, 120Hz)
Dissipation Factor
(tane)
0.08 max.
Low Temperature
Characteristics
Max. impedance ratio at 100kHz to the 20C value
Z(-25C)/Z(+20C)[1.15
Z(
-55C)/Z(+20C)[1.25
Endurance
The following specifications shall be satisfied when the capacitors are restored to 20C after the rated voltage is applied for 2000 hours
at 105C.
Appearance
Capacitance change
D.F. (tanE)
No significant damage
[P20% of the initial measured value
[150% of the initial specified value
[150% of the initial specified value
[The initial specified value
ESR
Leakage current
Bias Humidity Test The following specifications shall be satisfied when the capacitors are restored to 20C after subjecting them to DC voltage at 60C,
90 to 95% RH for 1000 hours.
Appearance
Capacitance change
D.F. (tanE)
No significant damage
[P20% of the initial measured value
[150% of the initial specified value
[150% of the initial specified value
[The initial specified value
ESR
Leakage current
Surge Voltage Test The capacitors shall be subjected to 1000 cycles each consisting of charge with the surge voltage specified at 105C for 30 seconds
through a protective resistor(R=1kO) and discharge for 5 minutes 30 seconds.
Appearance
Capacitance change
D.F. (tanE)
No significant damage
[P20% of the initial measured value
[150% of the initial specified value
[150% of the initial specified value
[The initial specified value
ESR
Leakage current
Failure Rate
1% per 1000 hours maximum (Confidence level 60% at 105C)
*Note : If any doubt arises, measure the leakage current after the following voltage treatment.
Voltage treatment : DC rated voltage is applied to the capacitors for 120 minutes at 105C.
?DIMENSIONS [mm]
?MARKING
Coated Case
EX) 4V560MF
292
A
560
4V
fD
L
8
11.5
3.5
10
11.5
5.0
F
L+1.5 max.
15min.
4min.
(1/2)
CAT. No. E1001D