PI74FCT16952T/162952/162H952T
PI74FCT16952T
16-BIT REGISTEPRIE7D4TFRCATNS1C6E2I9V5E2RTS
PI74FCT162H952T
16-Bit Registered Transceivers
ProductFeatures:
CommonFeatures:
Product Description:
Pericom Semiconductor’s PI74FCT series of logic circuits are pro-
duced in the Company’s advanced 0.6 micron CMOS technology,
achieving industry leading speed grades.
• PI74FCT16952T,PI74FCT162952T,andPI74FCT2H952T
are high-speed,
low power devices with high current drive
• VCC =5V±10%
ThePI74FCT16952T,PI74FCT162952T,and PI74FCT162H952T
are 16-bit registered transceivers organized with two sets of eight
D-type latches with separate input and output controls for each set.
For data flow from A to B, for example, the A-to-B Enable
(xCEAB) input must be LOW in order to enter data from xAx. The
data present on the A port will be clocked on the B register when
xCLKAB toggles from LOW-to-HIGH. The xOEAB control
performs the output enable function on the B port. Control of data
from B to A is similar, but uses the xCEBA, xCLKBA, and xOEBA
inputs. By connecting the control pins of the two independent
transceivers together, a full 16-bit operation can be achieved. The
output buffers are designed with a Power-Off disable allowing
“live insertion” of boards when used as backplane drivers.
• Hysteresis on all inputs
• Packagesavailable:
– 56-pin240milwideplasticTSSOP(A)
– 56-pin300milwide plasticSSOP(V)
PI74FCT16952TFeatures:
• High output drive: IOH = –32 mA; IOL = 64 mA
• Power off disable outputs permit “live insertion”
• Typical VOLP (Output Ground Bounce) < 1.0V
atVCC =5V,TA =25°C
PI74FCT162952TFeatures:
The PI74FCT16952T output buffers are designed with a Power-
Off disable function allowing “live insertion” of boards when used
as backplane drivers.
• Balanced output drivers: ±24 mA
• Reduced system switching noise
The PI74FCT162952T has ±24 mA balanced output drivers. It is
designed with current limiting resistors at its outputs to control the
output edge rate resulting in lower ground bounce and undershoot.
This eliminates the need for external terminating resistors for most
interface applications.
• Typical VOLP (Output Ground Bounce) < 0.6V
atVCC =5V,TA =25°C
PI74FCT162H952TFeatures:
• Bus Hold retains last active bus state during 3-state
• Eliminates the need for external pull-up resistors
The PI74FCT162H952T has “Bus Hold” which retains the input’s
last state whenever the input goes to high-impedance preventing
“floating”inputsandeliminatingtheneedforpull-up/downresistors.
Logic Block Diagram
1OEBA
2OEBA
1CEBA
2CEBA
1
CLKBA
OEAB
CEAB
2
CLKBA
OEAB
CEAB
1
2
1
2
1CLKAB
2CLKAB
C
C
1A
0
2A0
1B
0
2B0
D
D
C
C
D
D
TO 7 OTHER CHANNELS
TO 7 OTHER CHANNELS
PS2042A 03/11/96
1