PEEASeries
Conductive Polymer Aluminum
Solid Capacitor (Radial Type)
MERITEK
RoHS
FEATURES
Standard radial lead type, high voltage
Rated voltage: 2.5VDC ~35VDC
Endurance: 2000hours at 105ºC
Suitable for DC-DC converters, voltage regulators and decoupling applications.
SPECIFICATIONS
Item
Characteristic
Category Temperature Range
Rated Voltage Range
Surge Voltage
-55ºC ~ +105C
2.5VDC ~ 35VDC
Rated voltage x 1.15V
M=±20%
at 105C
Capacitance Tolerance
Leakage Current
at 120Hz, 20ºC
Shall not exceed values shown in standard ratings
0.12 (max)
at 20ºC after 2 minutes
at 120Hz, 20ºC
Dissipation Factor ( tan )
Temperature Stability
Impedance change
Z(-55ºC)/Z(+20ºC)≤1.25
Z(+105ºC)/Z(+20ºC)≤1.25
at -55C, 100kHz
at +105C, 100kHz
Endurance
Appearance: no significant damage
The specifications shall be satisfied when
the capacitors are restored to 20ºC after
the rated voltage is applied for 2000hours
at 105ºC
Capacitance change: ≤ ±20% of the initial value
DF(tanδ): ≤ 150% of the initial specified value
ESR: ≤ 150% of the initial specified value
Leakage current: ≤ the initial specified value
Damp Heat, Steady State
Surge Voltage
Appearance: no significant damage
The specifications shall be satisfied when
the capacitors are restored to 20ºC after
subjecting them to store at 60ºC, 90%~
95% R.H. for 1000hours, without DC
applied.
Capacitance change: ≤ ±20% of the initial value
DF(tanδ): ≤ 150% of the initial specified value
ESR: ≤ 150% of the initial specified value
Leakage current: ≤ the initial specified value
Appearance: no significant damage
The capacitors shall be subjected to
1,000 cycles each consisting of charge
with the surge voltages specified at
105ºC for 30 seconds through a
protective resistor (R=1kΩ) and
Capacitance change: ≤ ±20% of the initial value
DF(tanδ): ≤ 150% of the initial specified value
ESR: ≤ 150% of the initial specified value
Leakage current: ≤ the initial specified value
discharge for 5 minutes 30 seconds
NOTE:
If any doubt arises, measure the leakage current after following voltage treatment -
Voltage treatment: DC rated voltage is applied to the capacitors for 60 minutes at 105ºC
DIMENSIONS (mm)
Size code
BD+0.5 (max)
BL,(max)
Φd±0.05
0406
0606
6.3
0609
6.3
0809
8.0
0812
8.0
1012
10.0
12.0
0.6
4.0
6.0
6.0
9.0
9.0
12.0
0.6
0.45
1.5
0.45
2.5
0.6
0.6
LS±0.4
2.5
3.5
3.5
5.0
LL±0.3
3.2
3.2
3.2
3.2
3.2
3.2
Rev. 7