January 2008
rev 1.3
P1708C
Low Power Notebook LCD Panel EMI Reduction IC
Features
down stream clock and data dependent signals. The
P1708C allows significant system cost savings by reducing
the number of circuit board layers ferrite beads, shielding
and other passive components that are traditionally
required to pass EMI regulations.
•
•
FCC approved method of EMI attenuation.
Generates a low EMI spread spectrum clock of the
input frequency.
•
•
Optimized for frequency range from 50 to 110MHz.
Internal loop filter minimizes external components and
board space.
The P1708C modulates the output of a single PLL in order
to “spread” the bandwidth of a synthesized clock, and more
importantly, decreases the peak amplitudes of its
harmonics. This results in significantly lower system EMI
compared to the typical narrow band signal produced by
oscillators and most frequency generators. Lowering EMI
by increasing a signal’s bandwidth is called ‘spread
spectrum clock generation’.
•
•
•
•
•
Four selectable spread ranges.
Low inherent cycle-to-cycle jitter.
3.3V operating voltage range.
TTL or CMOS compatible inputs and outputs.
Ultra-low power CMOS design.
•
•
•
•
8.46 mA @3.3V, 54MHz
9.79 mA @3.3V, 65MHz
12.06 mA @3.3V, 81MHz
16.51 mA @3.3V, 108MHz
The P1708C uses the most efficient and optimized
modulation profile approved by the FCC and is
implemented in a proprietary all digital method.
•
•
•
•
Supports notebook VGA and other LCD timing
controller applications.
Pinout compatible to ICS MK1708 and Cypress
CY25560.
SSON/SBM pin for Spread Spectrum On/Off and
Standby Mode controls.
Applications
Available in 8-pin SOIC and TSSOP.
The P1708C is targeted towards notebook LCD displays,
and other displays using an LVDS interface, PC peripheral
devices, and embedded systems.
Product Description
The P1708C is a versatile spread spectrum frequency
modulator designed specifically for input clock frequencies.
The P1708C reduces electromagnetic interference (EMI) at
the clock source, allowing system wide reduction of EMI of
VDD
SR0
SSON
SR1
Block Diagram
PLL
Modulation
CLKIN
Frequency
Divider
Output
Divider
Phase
Detector
Loop
Filter
VCO
Feedback
Divider
ModOUT
VSS
PulseCore Semiconductor Corporation
1715 S. Bascom Ave Suite 200, Campbell, CA 95008 • Tel: 408-879-9077 • Fax: 408-879-9018
www.pulsecoresemi.com
Notice: The information in this document is subject to change without notice.