NSiP83086
Datasheet (EN) 1.1
18
19
20
A
Non-inverting Receiver Input
Isolated Power Supply Output. This pin must be connected externally to VISOIN. It is recommended
this pin have a 0.1 μF and 10μF capacitor to GND2 (Pin20). Connect this pin through a ferrite bead
and short trace length to VISOIN for operation.
VISOOUT
GND2
Ground 2, the ground reference for Isolator Side 2
Figure 1.2 NSiP83086C-DSWTR Package
Table1.2NSiP83086C-DSWTR Pin Configuration and Description
PIN NO.
SYMBOL
FUNCTION
1
GND1
Ground 1, the ground reference for Isolator Side 1
Power Supply for Isolator Side 1, It is recommended this pin have a 0.1μF + 10 μF capacitor to
2
VDD1
GND1 (Pin1, Pin3)
3
4
GND1
R
Ground 1, the ground reference for Isolator Side 1
Receiver output
5
/RE
DE
Receiver enable input, this is an active low input
Driver enable input, this is an active high input
Driver transmit data input
6
7
D
8
VDDL
GND1
GND1
I/O Power Supply input, Side1 I/O logic level
Ground 1, the ground reference for Isolator Side 1
Ground 1, the ground reference for Isolator Side 1
9
10
VISO output voltage select, VISOOUT =5V when SEL is floating or connect to VISOIN, VISOOUT =3.3V
when SEL short to GND2
Isolated power supply Input. This pin must be connected externally to VISOOUT. It is
recommended this pin have a 0.1 μF capacitor to GND2. Connect this pin to VISOOUT through a
ferrite bead and short trace length for operation.
11
12
SEL
VISOIN
Non-inverting Driver Output. When the driver is disabled, or when VDDL is powered down, Pin Y
is put into a high impedance state to avoid overloading the bus.
13
14
Y
GND2
Ground 2, the ground reference for Isolator Side 2
Copyright © 2023, NOVOSENSE
Page 4