NN30196A
VIN = 4.5 V to 5.6 V, 9 A
Synchronous DC-DC Step down Regulator
comprising of Controller IC and Power MOSFET
FEATURES
DESCRIPTION
z High-Speed Response DC-DC Step Down Regulator
Circuit that employs Hysteretic Control System
NN30196A is a synchronous DC-DC Step down
Regulator (1-ch) comprising of a Controller IC and two
power MOSFETs and employs the hysteretic control
system.
z Two 9 mΩ (Typ.)
MOSFETs for High Efficiency at 9 A
z SKIP (discontinuous) Mode for Light Load Efficiency
z Up to 9 A Output Current
By this system, when load current changes suddenly, it
responds at high speed and minimizes the changes of
output voltage.
Since it is possible to use capacitors with small
capacitance and it is unnecessary to add external parts
for system phase compensation, this IC realizes
downsizing of set and reducing in the number of external
parts. Output voltage is adjustable by user.
z Input VoltageRange : AVIN : 4.5 V to 5.6 V
PVIN : 3.1 V to 5.6 V
Output Voltage Range : 0.6 V to 3.5 V
Selectable Switching Frequency 500 kHz , 1 MHz ,
2 MHz
Maximum current is 9 A.
z Adjustable Soft Start
z Low Operating and Standby Quiescent Current
APPLICATIONS
z Open Drain Power Good Indication for Output Over ,
High Current Distributed Power Systems such as
・HDDs (Hard Disk Drives)
・SSDs (Solid State Drives)
・PCs
Under Voltage
z Built-in Under Voltage Lockout (UVLO),
Thermal Shut Down (TSD),
Over Voltage Detection (OVD),
・Game consoles
Under Voltage Detection (UVD),
・Servers
Over Current Protection (OCP),
・Security Cameras
・Network TVs
Short Circuit Protection (SCP)
z HQFN040-A3-0606 ( Size:6 mmX6 mm,0.5mm pitch )
・Home Appliances
・OA Equipment etc.
40pin Plastic Quad Flat Non-leaded Package Heat
Slug Down (QFN Type)
SIMPLIFIED APPLICATION
VREG
EFFICIENCY CURVE
Frequency = 500 kHz
100
90
80
70
60
50
40
30
20
10
0
PVIN
CTL1
CTL2
PVIN
100k Ω
PGOOD
BST
VOUT
AVIN
AVIN
FCCM/ Vo= 1.0V
FCCM/ Vo= 1.2V
FCCM/ Vo= 1.8V
FCCM/ Vo= 3.3V
SKIP/ Vo= 1.0V
SKIP/ Vo= 1.2V
SKIP/ Vo= 1.8V
SKIP/ Vo= 3.3V
NN30196A
0.1μF
1μH
DCDCOUT 1.2 V
LX
1k Ω
1k Ω
VFB
22μF x 3
SS
VREG
PGND
AGND
1μF 10nF
Notes) This application circuit is an example. The operation
of mass production set is not guaranteed. You should
perform enough evaluation and verification on the
design of mass production set. You are fully
responsible for the incorporation of the above
application circuit and information in the design of
your equipment.
IOUT (A)
Condition )
V
IN = 5 V, Vout = 1.0 V , 1.2 V , 1.8 V , 3.3 V
Lo = 1 µH, Co = 66 µF ( 22 µF x 3 ), Frequency = 500 kHz
Publication date: October 2012
Ver. BEB
1