NGC1081
Features
NGC1081 is an IC, suitable and optimized for NFC communication controlled actuation and
sensing. It contains a NFC transceiver, an actuation interface, a sensing unit, a microcontroller
and wired communication interfaces. NGC1081 is available in a 32-pin package.
The chip can operate in two different power supply modes:
• active supply mode:
- The chip is supplied by an external 3V power supply source (e.g. battery).
• passive supply mode:
- The chip is harvesting energy from the external NFC RF field. No additional external supply
source is required. Of course, operation of the chip requires the presence of the NFC field in this
use case. The chip can charge external capacitors, in order to store harvested energy. External
storing capacitors can be used to store the required amount of energy to initiate an actuation
action (e.g. to drive a motor).
Main product features are:
• contact-less communication interface NFC
- PICC according to ISO/ IEC 14443 Type A
- data rate 106 kBit/s
- initialization and anti-collision protocol processed in firmware
- proprietary and customizable application protocol optimized for end custom applications
• Integrated microcontroller
- 32-bit ARM Cortex-M0 CPU operating at clock frequency of 28 MHz
- nested vector interrupt controller with 18 interrupts
- integrated system tick timer (SysTick)
- MicroDMA with 8 DMA channels
- 16 kByte integrated ROM containing start-up code and system development kit sofꢀare library
- 16 kByte integrated SRAM
- 60 kByte integrated non volatile flash memory
- Serial Wire Debug interface
- multilayer AHB-Lite on chip interconnect
• Digital Peripherals
- Up to 16 programmable and configurable General Purpose Input/ Outputs (GPIO)
- System Timer Unit containing six independent timer channels and PWM generator
- watchdog timer
- arithmetic divide operation hardware accelerator
- full duplex capable UART transceiver with Rx/ Tx FIFOs
- SPI master/ slave transceiver with Rx/ Tx FIFOs
- AES accelerator
- I²C master/ slave transceiver
- Real Time Clock
• Actuation interface
- integrated H-Bridge driver capable to direct drive a motor up to peak current of 250 mA
- ability to control an external H-bridge driver IC by applying gate drive control signals to GPIO
• Sensing Interface
- Analog to Digital Converter (12-Bit SAR) with four different Input channels
- Digital to Analog Converter (10-Bit)
- Comparator
- Current to Voltage Converter
Datasheet
www.infineon.com
Please read the sections "Important notice" and "Warnings" at the end of this document
Rev. 1.0
20223-02-16