Document Number MKE02P64M40SF0
Rev. 4, 07/2016
NXP Semiconductors
Data Sheet: Technical Data
MKE02P64M40SF0
KE02 Sub-Family Data Sheet
Supports the following:
MKE02Z16VLC4(R),
MKE02Z32VLC4(R),
MKE02Z64VLC4(R),
MKE02Z16VLD4(R),
MKE02Z32VLD4(R),
MKE02Z64VLD4(R),
MKE02Z32VLH4(R),
MKE02Z64VLH4(R),
MKE02Z32VQH4(R),
MKE02Z64VQH4(R),
MKE02Z16VFM4(R),
MKE02Z32VFM4(R), and
MKE02Z64VFM4(R)
Key features
• System peripherals
– Power management module (PMC) with three power
modes: Run, Wait, Stop
– Low-voltage detection (LVD) with reset or interrupt,
selectable trip points
– Watchdog with independent clock source (WDOG)
– Programmable cyclic redundancy check module
(CRC)
– Serial wire debug interface (SWD)
– Bit manipulation engine (BME)
• Operating characteristics
– Voltage range: 2.7 to 5.5 V
– Flash write voltage range: 2.7 to 5.5 V
– Temperature range (ambient): -40 to 105°C
• Performance
– Up to 40 MHz ARM® Cortex-M0+ core and up to
20 MHz bus clock
– Single cycle 32-bit x 32-bit multiplier
– Single cycle I/O access port
• Security and integrity modules
• Memories and memory interfaces
– Up to 64 KB flash
– 64-bit unique identification (ID) number per chip
• Human-machine interface
– Up to 256 B EEPROM
– Up to 4 KB RAM
– Up to 57 general-purpose input/output (GPIO)
– Two up to 8-bit keyboard interrupt modules (KBI)
– External interrupt (IRQ)
• Clocks
– Oscillator (OSC) - supports 32.768 kHz crystal or 4
MHz to 20 MHz crystal or ceramic resonator; choice
of low power or high gain oscillators
– Internal clock source (ICS) - internal FLL with
internal or external reference, 31.25 kHz pre-
trimmed internal reference for 32 MHz system clock
(able to be trimmed for up to 40 MHz system clock)
– Internal 1 kHz low-power oscillator (LPO)
• Analog modules
– One up to 16-channel 12-bit SAR ADC, operation in
Stop mode, optional hardware trigger (ADC)
– Two analog comparators containing a 6-bit DAC
and programmable reference input (ACMP)
NXP reserves the right to change the production detail specifications as may be
required to permit improvements in the design of its products.