MIC5209
ELECTRICAL CHARACTERISTICS (CONTINUED)
Electrical Characteristics: VIN = VOUT + 1V; IL = 100 μA; TJ = +25°C, bold values indicate –40°C ≤ TJ ≤ +125°C
except 0°C ≤ TJ ≤ +125°C for 1.8V ≤ VOUT ≤ 2.5V, unless noted. Note 1
Parameter
Enable Input
Symbol
Min.
Typ.
Max.
Units
Conditions
—
—
2.0
—
—
—
—
—
—
—
—
0.4
0.18
—
V
V
VEN = Logic-low (Regulator shutdown)
Enable Input Logic-Low
Voltage
VENL
—
VEN = Logic-high (Regulator enabled)
VENL ≤ 0.4V
0.01
0.01
5
–1
Enable Input Current
IENL
µA
–2
VENL ≤ 0.18V
20
VENH = 2.0V
—
25
—
IENH
µA
—
30
VENH = 16V
—
50
Note 1: Specification for packaged product only.
2: Output voltage temperature coefficient is defined as the worst-case voltage change divided by the total
temperature range.
3: Regulation is measured at constant junction temperature using low duty cycle pulse testing. Parts are
tested for load regulation in the load range from 100 µA to 500 mA. Changes in output voltage due to heat-
ing effects are covered by the thermal regulation specification.
4: Dropout Voltage is defined as the input to output differential at which the output voltage drops 2% below its
nominal value measured at 1V differential.
5: Ground pin current is the regulator quiescent current plus pass transistor base current. The total current
drawn from the supply is the sum of the load current plus the ground pin current.
6:
VEN is the voltage externally applied to devices with the EN (enable) input pin. SOIC-8 (M) and DDPAK (U)
packages only.
7: Thermal regulation is the change in output voltage at a time “t” after a change in power dissipation is
applied, excluding load or line regulation effects. Specifications are for a 500 mA load pulse at VIN = 16V
for t = 10 ms.
8:
CBYP is an optional, external bypass capacitor connected to devices with a BYP (bypass) or ADJ (adjust)
pin. SOIC-8 (M) and DDPAK (U) packages only.
DS20005720B-page 6
2017 - 2022 Microchip Technology Inc. and its subsidiaries