MIC5191
Ultra High-Speed, High-Current
Active Filter / LDO Controller
General Description
Features
The MIC5191 is an ultra high-speed linear regulator. It
uses an external N-Channel FET as its power device.
• Input voltage range: VIN = 1.0V to 5.5V
• +1.0% initial output tolerance
The MIC5191's ultra high-speed abilities can handle the
fast load demands of microprocessor cores, ASICs, and
other high-speed devices. Signal bandwidths of greater
than 500 kHz can be achieved with a minimum amount of
capacitance while at the same time keeping the output
voltage clean, regardless of load demand. A powerful
output driver delivers large MOSFETs into their linear
regions, achieving ultra-low dropout voltage.
• Dropout down to 25mV@10A
• Filters out switching frequency noise on input
• Very high large signal bandwidth >500kHz
• PSRR >40dB at 500kHz
• Adjustable output voltage down to 1.0V
• Stable with any output capacitor
• Excellent line and load regulation specifications
• Logic controlled shutdown
1.25VIN ±10% can be turned into 1V ±1% without the use
of a large amount of capacitance.
• Current limit protection
MIC5191 (1.0V reference) is optimized for output voltages
of 1.0V and higher.
The MIC5191 is offered in 10-pin 3mm×3mm MLF® and
10-pin MSOP-10 packages and has an operating junction
temperature range of –40°C to +125°C.
• 10-pin MLF® and MSOP-10 packages
• Available –40°C to +125°C junction temperature
Applications
Data sheets and support documentation can be found on
Micrel’s web site at www.micrel.com.
• Distributed power supplies
• ASIC power supplies
• DSP, µP, and µC power supplies
___________________________________________________________________________________________________________
Typical Application
VCC =12V
C1
0.01µF
VIN 1.2V
V
OUT 1.0V@7A
IR3716S
MIC5191
IS
OUT
FB
VIN
VCC1
VCC2
EN
C2
10µF
PGND
SGND
C3
0.01µF
COMP
R3
GND
GND
PowerPAK is a trademark of Siliconix, Inc.
MLF and MicroLeadFrame are registered trademarks of Amkor Technology, Inc.
Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1 (408) 944-0800 • fax + 1 (408) 474-1000 • http://www.micrel.com
M9999-122206
December 2006
1