5秒后页面跳转
MIC4833 PDF预览

MIC4833

更新时间: 2024-11-25 10:56:59
品牌 Logo 应用领域
麦瑞 - MICREL 驱动器
页数 文件大小 规格书
12页 1161K
描述
Low Noise Dual 220 VPP EL Driver With Output Voltage Slew Rate Control

MIC4833 数据手册

 浏览型号MIC4833的Datasheet PDF文件第2页浏览型号MIC4833的Datasheet PDF文件第3页浏览型号MIC4833的Datasheet PDF文件第4页浏览型号MIC4833的Datasheet PDF文件第5页浏览型号MIC4833的Datasheet PDF文件第6页浏览型号MIC4833的Datasheet PDF文件第7页 
MIC4833  
Low Noise Dual 220 VPP EL Driver  
With Output Voltage Slew Rate Control  
General Description  
Features  
Drives two EL panels, up to 4 in2 each at full  
brightness  
The MIC4833 is a low noise dual Electroluminescent (EL)  
Panel driver used in backlighting applications. The  
MIC4833 converts a low DC voltage to a high DC voltage  
using a boost converter and then alternates the high DC  
voltage across the EL panels using an H-bridge. The  
MIC4833 incorporates internal wave-shaping circuitry  
specifically designed to reduce audible noise emitted by  
EL panels. The two EL panels may be dimmed by applying  
a PWM signal to the device. The MIC4833 drives two  
outputs from a single inductor and requires a minimum  
number of passive components. It features an operating  
input voltage range of 2.3V to 5.8V, making it suitable for  
1-cell Li-ion and 2- or 3-cell alkaline/NiCad/NiMH battery  
applications.  
Independent input control for each of the two panels  
and allows PWM dimming.  
220Vpp regulated AC output waveform  
2.3V to 5.8V DC input voltage  
Wave-shaping circuit to reduce audible noise  
Adjustable slew rate for audible noise reduction  
Independently adjustable boost converter and EL  
panel frequency  
Single inductor to power both panels  
0.1uA typical shutdown current  
12 pin 3mmx3mm MLF® package  
–40oC to +125oC junction temperature range  
An external resistor may be used to adjust the output  
voltage slew rate to reduce audible noise. The MIC4833  
features separate oscillators for the boost and H-bridge  
stages to allow independent control. External resistors set  
the operating frequencies of each stage allowing the EL  
circuit to optimize efficiency and brightness.  
Applications  
Mobile Phones  
MP3s/Portable Media Players (PMP)  
Clocks/ Watches  
Remote Controls  
Cordless Phones  
GPS Devices  
The MIC4833 is available in a 12 pin 3mmx3mm MLF®  
package, and has an operating junction temperature range  
of –40°C to +125°C.  
PDAs  
_________________________________________________________________________________________________  
Typical Application  
High  
50k  
Low  
ENA  
VDD  
RSW  
REL  
ENB  
GND  
SLEW  
ELA  
ELB  
COM  
CS  
VIN  
Li Ion  
3V to 4.2V  
EL Lamp A  
EL Lamp B  
332k  
0.01µF  
MIC4833  
1.78M  
High  
High  
Low  
Low  
SW  
VIN  
Li Ion  
3V to 4.2V  
220µH  
2.2nF  
250V  
10µF  
Low Noise Dual EL Driver  
MLF and MicroLead Frame are registered trademark of Amkor Technologies  
Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1 (408) 944-0800 • fax + 1 (408) 474-1000 • http://www.micrel.com  
M9999-100308  
(408) 955-1690  
October 2008  

与MIC4833相关器件

型号 品牌 获取价格 描述 数据表
MIC4833YML MICREL

获取价格

Low Noise Dual 220 VPP EL Driver With Output Voltage Slew Rate Control
MIC4833YML-TR MICROCHIP

获取价格

EL DISPLAY DRIVER, DSO12
MIC4834 MICREL

获取价格

Low Noise Dual 220 VPP EL Driver
MIC4834YML MICREL

获取价格

Low Noise Dual 220 VPP EL Driver
MIC4834YMLTR MICREL

获取价格

EL DISPLAY DRIVER, DSO10, 3 X 3 MM, ROHS COMPLIANT, MLF-10
MIC4834YML-TR MICROCHIP

获取价格

EL Driver, 3 X 3 MM, ROHS COMPLIANT, MLF-10
MIC4834YMM MICREL

获取价格

Low Noise Dual 220 VPP EL Driver
MIC4834YMM MICROCHIP

获取价格

EL Driver, 1-Segment, PDSO10, ROHS COMPLIANT, MSOP-10
MIC4834YMM-TR MICROCHIP

获取价格

EL Driver, PDSO10, ROHS COMPLIANT, MSOP-10
MIC49150 MICREL

获取价格

1.5A Low Voltage LDO Regulator w/Dual Input Voltages