5秒后页面跳转
MIC4823MS PDF预览

MIC4823MS

更新时间: 2024-11-21 20:08:23
品牌 Logo 应用领域
美国微芯 - MICROCHIP 驱动光电二极管接口集成电路
页数 文件大小 规格书
8页 100K
描述
EL DISPLAY DRIVER, PDSO8

MIC4823MS 技术参数

生命周期:Active包装说明:LSOP,
Reach Compliance Code:compliantECCN代码:EAR99
HTS代码:8542.39.00.01风险等级:5.71
接口集成电路类型:EL DISPLAY DRIVERJESD-30 代码:R-PDSO-G8
长度:5.2 mm复用显示功能:NO
功能数量:1区段数:1
端子数量:8最高工作温度:85 °C
最低工作温度:-25 °C封装主体材料:PLASTIC/EPOXY
封装代码:LSOP封装形状:RECTANGULAR
封装形式:SMALL OUTLINE, LOW PROFILE认证状态:Not Qualified
座面最大高度:1.7 mm最大供电电压:9.5 V
最小供电电压:2 V表面贴装:YES
技术:CMOS温度等级:OTHER
端子形式:GULL WING端子节距:1.27 mm
端子位置:DUAL宽度:4.4 mm
Base Number Matches:1

MIC4823MS 数据手册

 浏览型号MIC4823MS的Datasheet PDF文件第2页浏览型号MIC4823MS的Datasheet PDF文件第3页浏览型号MIC4823MS的Datasheet PDF文件第4页浏览型号MIC4823MS的Datasheet PDF文件第5页浏览型号MIC4823MS的Datasheet PDF文件第6页浏览型号MIC4823MS的Datasheet PDF文件第7页 
MIC4823  
High Voltage EL Lamp Driver  
Advance Information  
General Description  
Features  
The MIC4823 is a high-voltage driver designed for driving EL  
lamps of up to 50nF (typically 16 square inches). EL lamps  
greater tan 50nF can bedriven for applicatinons not requiring  
high brightness. The input supply voltage range is from 2.0V  
to 9.5V. The device uses a single inductor and a minimum  
number of passive components. The nominal regulated out-  
put voltage that is applied to the EL lamp is ±90V. The chip  
• Processed with high voltage CMOS technology  
• 2.0V to 9.5V operating supply voltage  
• DC to AC conversion  
• 180V peak-to-peak typical output voltage  
• Large output load capability typically 50nF  
• Permits the use of high-resistance elastometric lamp  
connectors  
canbeenabledbyconnectingtheresistoronR  
and disabled by connecting them to ground.  
toV  
• Adjustable output lamp frequency to control lamp color,  
lamp life, and power consumption  
SW-OSC  
DD  
• Adjustable converter frequency to eliminate harmonics  
and optimize power consumption  
• Enable/disable function  
The MIC4823 has two internal oscillator, a switching MOS-  
FET, andahighvoltageELlampdriver. Thefrequencyforthe  
switching MOSFET is set by an external resistor connected  
• Low current draw under no load condition  
between the R  
pin and the V  
pin. An external  
SW-OSC  
DD  
inductor is connected between L and V pins. A 0.01µF to  
Applications  
• Handheld personal computers  
• Electronic personal organizers  
• Cellular Phones  
• Pagers  
• Portable instrumentation  
• GPS units  
X
DD  
0.1µF capacitor is connected between the C pin and GND.  
S
The EL lamp is conected between V and V .  
A
B
The switching MOSFET charges the external inductor and  
discharges it into the capacitor at C . The voltage at C will  
S
S
start to increase. Once the voltage at C reaches a nominal  
S
value of 90V, the switching MOSFET is turned OFF to  
conserve power. The outputs V and V are configured as an  
A
B
Ordering Information  
H-bridge and are switcng in oppisite states to achieve 180V  
peak-to-peak across the EL lamp.  
Part Number  
MIC4823MS  
MIC4823M  
Junction Temp. Range*  
–25°C to +85°C  
Package  
8-lead MSOP  
8-lead SOP  
–25°C to +85°C  
Typical Application  
0.1•F  
µ
Micrel, Inc. • 1849 Fortune Drive • San Jose, CA 95131 • USA • tel + 1 (408) 944-0800 • fax + 1 (408) 944-0970 • http://www.micrel.com  
July 2000  
1
MIC4823  

与MIC4823MS相关器件

型号 品牌 获取价格 描述 数据表
MIC4826 MICREL

获取价格

Low Input Voltage, 160VPP Output Voltage, EL Driver
MIC4826 MICROCHIP

获取价格

Micrel's MIC4826 is a high output voltage, DC to AC converter, designed for driving electr
MIC4826_09 MICREL

获取价格

Low Input Voltage, 160VPP Output Voltage, EL Driver
MIC4826BMM MICREL

获取价格

Low Input Voltage, 160VPP Output Voltage, EL Driver
MIC4826BMM ROCHESTER

获取价格

EL DISPLAY DRIVER, PDSO8, MSOP-8
MIC4826BMM MICROCHIP

获取价格

EL Driver, 1-Segment, PDSO8, MSOP-8
MIC4826BMMTR MICROCHIP

获取价格

EL Driver, 1-Segment, PDSO8, MSOP-8
MIC4826BMMTR ROCHESTER

获取价格

EL DISPLAY DRIVER, PDSO8, MSOP-8
MIC4826M MICROCHIP

获取价格

EL DISPLAY DRIVER, PDSO8
MIC4826MS MICROCHIP

获取价格

EL DISPLAY DRIVER, PDSO8