MC7800, MC7800A,
MC7800AE, NCV7800
1.0 A Positive Voltage
Regulators
These voltage regulators are monolithic integrated circuits designed
as fixed−voltage regulators for a wide variety of applications
including local, on−card regulation. These regulators employ internal
current limiting, thermal shutdown, and safe−area compensation. With
adequate heatsinking they can deliver output currents in excess of
1.0 A. Although designed primarily as a fixed voltage regulator, these
devices can be used with external components to obtain adjustable
voltages and currents.
http://onsemi.com
TO−220
T SUFFIX
CASE 221AB
Heatsink surface
connected to Pin 2.
1
2
Features
3
Output Current in Excess of 1.0 A
No External Components Required
Internal Thermal Overload Protection
Internal Short Circuit Current Limiting
Output Transistor Safe−Area Compensation
Output Voltage Offered in 1.5%, 2% and 4% Tolerance
2
D PAK−3
Pin 1. Input
2. Ground
3. Output
D2T SUFFIX
CASE 936
1
3
Heatsink surface (shown as terminal 4 in
case outline drawing) is connected to Pin 2.
4
2
Available in Surface Mount D PAK−3, DPAK−3 and Standard
DPAK−3
DT SUFFIX
CASE 369C
3−Lead Transistor Packages
2
1
NCV Prefix for Automotive and Other Applications Requiring
Unique Site and Control Change Requirements; AEC−Q100
Qualified and PPAP Capable
3
STANDARD APPLICATION
These are Pb−Free Devices
MC78XX
Input
Output
C **
MAXIMUM RATINGS (T = 25C, unless otherwise noted)
A
C *
in
0.33 mF
O
Value
Unit
369C 221A
936
Rating
Input Voltage
Symbol
A common ground is required between the
(5.0 − 18 V)
V
I
35
40
Vdc
W
input and the output voltages. The input voltage
must remain typically 2.0 V above the output
voltage even during the low point on the input
ripple voltage.
(24 V)
Power Dissipation
P
D
Internally Limited
Thermal Resistance,
Junction−to−Ambient
R
92
65
Figure C/W
q
JA
15
XX,
These two digits of the type number
indicate nominal voltage.
Thermal Resistance,
Junction−to−Case
R
5.0
5.0
5.0
C/W
q
JC
* C is required if regulator is located an
in
appreciable distance from power supply
filter.
Storage Junction Temperature
Range
T
−65 to +150
C
C
stg
** C is not needed for stability; however,
O
it does improve transient response. Values
of less than 0.1 mF could cause instability.
Operating Junction Temperature
T
+150
J
Stresses exceeding Maximum Ratings may damage the device. Maximum
Ratings are stress ratings only. Functional operation above the Recommended
Operating Conditions is not implied. Extended exposure to stresses above the
Recommended Operating Conditions may affect device reliability.
ORDERING INFORMATION
See detailed ordering and shipping information in the package
dimensions section on page 23 of this data sheet.
*This device series contains ESD protection and exceeds the following tests:
Human Body Model 2000 V per MIL_STD_883, Method 3015.
Machine Model Method 200 V.
DEVICE MARKING INFORMATION
See general marking information in the device marking
section on page 27 of this data sheet.
Semiconductor Components Industries, LLC, 2013
1
Publication Order Number:
May, 2013 − Rev. 26
MC7800/D