5秒后页面跳转
MAX17085BETL+ PDF预览

MAX17085BETL+

更新时间: 2024-01-24 04:57:11
品牌 Logo 应用领域
美信 - MAXIM 稳压器开关式稳压器或控制器电源电路开关式控制器输出元件信息通信管理
页数 文件大小 规格书
37页 3202K
描述
Integrated Charger, Dual Main Step-Down Controllers, and Dual LDO Regulators

MAX17085BETL+ 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Active包装说明:HVQCCN, LCC40,.2SQ,16
Reach Compliance Code:compliantECCN代码:EAR99
HTS代码:8542.31.00.01Factory Lead Time:6 weeks
风险等级:2.32其他特性:ALSO HAS 5V OUTPUT; ALSO OPERATES AS LDO REGULATOR
模拟集成电路 - 其他类型:SWITCHING REGULATOR控制模式:CURRENT-MODE
控制技术:PULSE WIDTH MODULATION最大输入电压:24 V
最小输入电压:4.5 V标称输入电压:19 V
JESD-30 代码:S-XQCC-N40JESD-609代码:e3
长度:5 mm湿度敏感等级:1
功能数量:1端子数量:40
最高工作温度:85 °C最低工作温度:-40 °C
标称输出电压:3.3 V封装主体材料:UNSPECIFIED
封装代码:HVQCCN封装等效代码:LCC40,.2SQ,16
封装形状:SQUARE封装形式:CHIP CARRIER, HEAT SINK/SLUG, VERY THIN PROFILE
峰值回流温度(摄氏度):260电源:5 V
认证状态:Not Qualified座面最大高度:0.8 mm
子类别:Power Management Circuits最大供电电流 (Isup):1.5 mA
标称供电电压 (Vsup):5 V表面贴装:YES
切换器配置:BUCK最大切换频率:800 kHz
技术:BICMOS温度等级:INDUSTRIAL
端子面层:Matte Tin (Sn)端子形式:NO LEAD
端子节距:0.4 mm端子位置:QUAD
处于峰值回流温度下的最长时间:NOT SPECIFIED宽度:5 mm
Base Number Matches:1

MAX17085BETL+ 数据手册

 浏览型号MAX17085BETL+的Datasheet PDF文件第2页浏览型号MAX17085BETL+的Datasheet PDF文件第3页浏览型号MAX17085BETL+的Datasheet PDF文件第4页浏览型号MAX17085BETL+的Datasheet PDF文件第5页浏览型号MAX17085BETL+的Datasheet PDF文件第6页浏览型号MAX17085BETL+的Datasheet PDF文件第7页 
19-5135; Rev 0; 1/10  
Integrated Charger, Dual Main Step-Down  
Controllers, and Dual LDO Regulators  
General Description  
Features  
S All-in-One Charger Plus Dual Main Step-Down  
The MAX17085B is an all-in-one notebook power solution  
integrating a multichemistry battery charger, dual fixed-  
output Quick-PWMK step-down controllers, and dual  
keep-alive linear regulators:  
Controllers  
S 5V/100mA and 3.3V/50mA LDO Regulators  
S Main  
Charger: The high-frequency (~1.4MHz) multichem-  
istry battery charger uses a current-mode, fixed  
inductor current ripple architecture that significantly  
reduces component size and cost. Low-offset sense  
amplifiers allow the use of low-value sense resistors  
for charging and input current limit.  
Dual Quick-PWM with Fast Transient Response  
and Extended On-Time  
300kHz to 800kHz Switching Frequency  
Fixed 5V and 3.3V SMPS Outputs  
Low-Noise Ultrasonic Mode  
Autoretry Fault Protection  
The charger uses n-channel switching MOSFETs.  
Adjustable charge current, charge voltage, and cell  
selection allow for flexible use with different battery  
packs. Charge current is set by an analog control input,  
or a PWM input. High-accuracy current-sense ampli-  
fiers provide fast cycle-by-cycle current-mode control to  
protect against short circuits to the battery and respond  
quickly to system load transients. Additionally, the char-  
ger provides a high-accuracy analog output that is pro-  
portional to the adapter current.  
S Charger  
High Switching Frequency (1.4MHz)  
Selectable 2-, 3-, and 4-Cell Battery Voltage  
Automatic Selection of System Power Source  
Internal Charge-Pump for Adapter n-Channel  
MOSFETs Drive  
Q0.4% Accurate Charge Voltage  
Q2.5% Accurate Input Current Limiting  
Q3% Accurate Charge Current  
S Monitor Outputs for  
An integrated charge pump controls an n-channel  
adapter selector switch. The charge pump remains  
active even when the charger is off. When the adapter  
is absent, a p-channel MOSFET selects the battery.  
AC Adapter Current (Q2% Accuracy)  
Battery Discharge Current (Q2% Accuracy)  
AC Adapter OK  
S Analog/PWM (100Hz to 500kHz) Adjustable  
Main SMPS: The dual Quick-PWM step-down con-  
trollers with synchronous rectification generate  
the 5V and 3.3V main power in a notebook. Low-  
side MOSFET sensing provides a simple low-cost,  
highly efficient valley current-limit protection. The  
MAX17085B also includes output undervoltage, out-  
put overvoltage, and thermal-fault protection.  
Charge Current Setting  
S AC Adapter Overvoltage and Overcurrent  
Protection  
Applications  
Notebook Computers  
PDAs and Mobile Communicators  
5V and 3.3V Supplies  
Separate enable inputs for each SMPS and a com-  
bined open-drain power-good output allow flex-  
ible power sequencing. Voltage soft-start reduces  
inrush current, while passive shutdown discharges  
the output through an internal switch. Fast transient  
response, with an extended on-time feature reduces  
output capacitance requirements. Selectable pulse-  
skipping mode and ultrasonic mode improve light-  
load efficiency. Ultrasonic mode operation maintains  
a minimum switching frequency at light loads, mini-  
mizing audible noise effects.  
2-to-4, Li+-Cell, Battery-Powered Devices  
Ordering Information  
PART  
TEMP RANGE  
PIN-PACKAGE  
MAX17085BETL+  
-40°C to +85°C  
40 TQFN-EP*  
+Denotes a lead(Pb)-free/RoHS-compliant package.  
*EP = Exposed pad.  
Dual LDO Regulators: An internal 5V/100mA LDO5 with  
switchover can be used to either generate the 5V bias  
needed for power-up or other lower power “always-on”  
suspend supplies. Another 3.3V/50mA LDO3 provides  
“always-on” power to a system microcontroller.  
Pin Configuration appears at end of data sheet.  
Quick-PWM is a trademark of Maxim Integrated Products, Inc.  
_______________________________________________________________ Maxim Integrated Products  
1
For pricing, delivery, and ordering information, please contact Maxim Direct at 1-888-629-4642,  
or visit Maxim’s website at www.maxim-ic.com.  

与MAX17085BETL+相关器件

型号 品牌 描述 获取价格 数据表
MAX17085BETL+T MAXIM Switching Regulator, Current-mode, 800kHz Switching Freq-Max, BICMOS, TQFN-40

获取价格

MAX17085GTL MAXIM Integrated Charger, Dual Main Step-Down Controllers, and Dual LDO Regulators

获取价格

MAX17088 MAXIM 35V to -25V High-Voltage Level-Shifting Drivers

获取价格

MAX17088ETX+ MAXIM Switching Regulator

获取价格

MAX17088EVCMAXQU+ MAXIM 35V to -25V High-Voltage Level-Shifting Drivers

获取价格

MAX17088EVKIT MAXIM 35V to -25V High-Voltage Level-Shifting Drivers

获取价格