MAX14836
24V Dual-Output Sensor Transceiver
General Description
Features and Benefits
● High Configurability and Integration Enable Faster
The MAX14836 transceiver is suitable for 24V binary
sensors. Additional 24V digital inputs and outputs are
provided. Two internal linear regulators generate common
sensor power requirements: 5V and 3.3V.
Time-to-Market and Reduce SKUs
• Push-Pull, High-Side, or Low-Side Outputs
• DIO and DO Drivers Can Be Connected in Parallel
to Increase Current and Reduce Output Resistance
• 200mA Specified DIO and DO Output Drive
• 2.5V to 5V Logic Interface Levels
• 5V and 3.3V Linear Regulators
• 400μs Wake-Up Detection on DIO Line
• 3μF DIO Load-Drive Capability
• 2μF DO Load-Drive Capability
On-board DIO and DO drivers are independently
configurable for push-pull, high-side (pnp), or low-side
(npn) operation. The device detects a wake-up condition
and generates a wake-up signal on the active-low WU
output.
An SPI interface allows configuration and monitoring of
the devices. Extensive alarm conditions are detected and
communicated through the IRQ output and the SPI inter-
face. The device features reverse-polarity, short-circuit,
and thermal protection. All power lines are monitored for
undervoltage conditions.
• EMI Emission Control Through Slew-Controlled
Driver
● Integrated Protection Enables Robust Solutions
• Reverse-Polarity-Protected 24V Supply Output
• SPI Interface for Configuration and Monitoring
Both DIO and DO drivers are specified for sinking/sourc-
ing 200mA.
• Reverse-Polarity and Short-Circuit Protection on All
24V Inputs/Outputs
• High-Temperature Warning and Thermal Shutdown
• Extensive Fault Monitoring and Reporting
The MAX14836 is available in a 4mm x 4mm, 24-pin
TQFN package, and is specified over the -40NC to +105NC
temperature range.
Applications
● Industrial Sensors
• -40°C to +105°C Operating Temperature Range
● Space-Saving 4mm x 4mm TQFN Package Saves
Circuit Footprint
Ordering Information appears at end of data sheet.
Typical Application Circuit
5V
10Ω
3.3V
1μF
1μF
0.1μF
10kΩ
0.8Ω
V
CC
V
L
DIOEN LDO33
V
5
LDOIN V
P
V
CC
UV
1μF
SPI
L+
4
DO
MAX14836
MICROCONTROLLER
1
2
LIO
LO
DIO
3
L-
GND
DODIS
GND
19-6738; Rev 2; 9/14