Click here for production status of specific part numbers.
MAX14483
6-Channel, Low-Power,
, SPI Digital Isolator
3.75kV
RMS
General Description
The MAX14483 is a 6-channel, 3.75kV
Benefits and Features
● Saves Space and Components
digital galvanic
RMS
• 6 Isolated Channels in a 20-SSOP Package
isolator using Maxim’s proprietary process technology.
The six signal channels are individually optimized for SPI
applications and include very low propagation delay on
the SDI, SDO, and SCLK channels. The SDO channel’s
tri-state control is enabled by the CS input as well as
a second enable control input pin (SDOEN), allowing
a single MAX14483 to isolate multiple SPI devices. To
simplify system design, an open-drain FAULT output can
be wire ORed with error outputs from other devices. In
addition, an auxiliary channel (AUX) is available for
passing timing or control signals from the master side
to the slave side and power monitors (SAA, SBA) are
provided for both power domains to signal if the opposite
side of the isolator is ready for operation. Independent
1.71V to 5.5V supplies on each side of the isolator also
make the device suitable for use as a level translator.
● Low Propagation Delay on SCLK, SDI, and SDO
• Up to 100MHz Clock, 200Mbps Data Rate
• 10ns Typical Propagation Delay
• 2ns Maximum Pulse Width Distortion
• 250ps Typical Peak Jitter
● Robust Galvanic Isolation of Digital Signals
• Withstands 3.75kV
for 60s (V
)
(V
RMS
• Continuously Withstands 450V
ISO
)
RMS IOWM
• Withstands ±10kV Surge between GNDA and
GNDB with 1.2/50µs Waveform
• High CMTI (50kV/µs, Typical)
● Flexible System Design
• Wide 1.71V to 5.5V Voltage Range on Each Side
• SDOEN Control Pin for Sharing Isolators
• Open-Drain FAULT Channel for Shared Interrupt
on Master Side
The MAX14483 has an isolation rating of 3.75kV
for
RMS
60 seconds and is available in a 20-pin SSOP package
with 5.5mm of creepage and clearance. The package
material has a minimum comparative tracking index (CTI)
of 400V, which gives it a group II rating in creepage tables.
• Auxiliary Channel for Timing or Control
● Low Power Consumption
• 1.53mW per Channel at SCLK = 10MHz with
V
DD
= 3.3V
The MAX14483 is rated for operation at ambient temperatures
of -40°C to +125°C.
• 0.77mW per Channel at SCLK = 10MHz with
V
DD
= 1.8V
Applications
Safety Regulatory Approvals
● Programmable Logic Controllers
● Industrial Automation
● Process Automation
● Building Automation
● Robotics
● UL According to UL1577
● cUL According to CSA Bulletin 5A
Ordering Information and Typical Operating Circuits appear
at end of data sheet.
● General SPI-bus Isolation
19-100011; Rev 4; 3/20