EVALUATION KIT AVAILABLE
Click here for production status of specific part numbers.
MAX13053A
MAX13054A
+5V, 2Mbps CAN Transceiver with ±65V
Fault Protection, ±25V CMR, and ±25kV ESD
General Description
Benefits and Features
The MAX13053A and MAX13054A are +5V CAN (Control
Area Network) transceivers with integrated protection
for industrial applications. These devices have extended
±65V fault protection for equipment where overvoltage
protection is required. It also incorporates high ±25kV
ESD HBM and an input common mode range (CMR) of
±25V, exceeding the ISO11898 specification of -2V to
+7V. This makes these parts well suited for applications
that are in electrically noisy environments, where the
ground planes are shifting relative to each other. This
family features a variety of options to address common
CAN application requirements; logic-level supply input
● Integrated Protection Increases Robustness
• ±65V Fault Tolerant CANH and CANL
• ±25kV ESD HBM (Human Body Model)
• ±25V Extended Common Mode Input Range
(CMR)
• Transmitter Dominant Timeout Prevents Lockup
• Short-Circuit Protection
• Thermal Shutdown
● Family Provides Flexible Design Options
• Slow Slew Rate to Minimize EMI
• Silent Mode S Disables Transmitter
• STBY Input for Low-Current Mode
V
L
for interfacing with 1.62V to 5.5V logic, low-current
• 1.62V to 5.5V Logic-Supply (V ) Range
L
standby mode, silent-mode to disable the transmitter, and
a slow slew rate to minimize EMI.
● High-Speed Operation of Up to 2Mbps
● Operating Temperature Range of -40°C to +125°C in
These devices operate at a high-speed CAN data rate,
allowing up to 2Mbps on small networks. Maximum speed
on large networks may be limited by the number of nodes
in a network, type of cabling, stub length, and other factors.
These transceivers include a dominant timeout to prevent
bus lockup caused by controller error or by a fault on
the TXD input. When TXD remains in the dominant state
8-pin SOIC Package
Ordering Information appears at end of data sheet.
(low) for longer than T
, the driver is switched to the
DOM
recessive state, releasing the bus. The MAX13053A
features a S pin where it enables and disables the
transmitter for applications where you need the
transceiver to receive only. The MAX13054A features a
STBY pin for 3 modes of operation; standby mode for low
current consumption, normal high speed mode, or a slow
slew rate mode when an external 26.1kΩ is connected
between ground and STBY pin.
The MAX13053A and MAX13054A are available in a
standard 8-pin SOIC package, and operate over the
-40°C to +125°C temperature range.
Applications
● Programmable Logic
● Instrumentation
● Smart Grid Equipment
● Drone
Controller
● Industrial Automation
● Building Automation
● Motor Control
19-100205; Rev 1; 5/18