MODEL: M6NPP
Screw Terminal Ultra-Slim Signal Conditioners M6N Series
[3] OUTPUT LOGIC
N: The same as the input
R: Inverted
PULSE ISOLATOR
Functions & Features
• 7.5-mm wide ultra-slim design
• Low profile allows the M6N module mounted in a 120-mm
deep panel
POWER INPUT
DC Power
R: 24 V DC
• Galvanically isolates pulse rate signals
• High-density mounting
(Operational voltage range 24 V ±10 %, ripple 10 %p-p max.)
• Power indicator and input monitor LED
[4] OPTIONS
blank: none
Typical Applications
/Q: With options (specify the specification)
• Isolating field pulse signals in order to reduce noises
• Changing e.g. dry contact signal to e.g. 5 V signals
SPECIFICATIONS OF OPTION: Q
COATING (For the detail, refer to M-System's web site.)
/C01: Silicone coating
7.5 (.30)
/C02: Polyurethane coating
102
(4.02)
GENERAL SPECIFICATIONS
Connection
Input and output: M3 screw terminal (torque 0.5 N·m)
Power input: Via the Installation Base (model: M6NBS)
or M3 screw terminal (torque 0.5 N·m)
Recommended solderless terminal: Max. 5.8 mm (0.23”)
wide; Ones with insulation sleeve do not fit.
102
(4.02)
mm (inch)
Applicable wire size: 0.2 – 2.5 mm
2
Housing material: Flame-resistant resin (black)
Isolation: Input to output to power
MODEL: M6NPP–[1][2][3]–R[4]
Chattering protection: Filter provided for mechanical
contact input
ORDERING INFORMATION
• Code number: M6NPP-[1][2][3]-R[4]
Specify a code from below for each [1] through [4].
(e.g. M6NPP-CMN-R/Q)
Power LED: Green light turns on when the power is supplied.
Input monitor LED
Open collector, Mechanical contact: Orange LED turns
on when the input is ON.
• Specify the specification for option code /Q
(e.g. /C01)
Voltage pulse, 2-wire current pulse: Orange LED turns
on when the input is high.
Input pulse sensing: DC coupled
[1] INPUT
A1: Open collector
■Recommended solderless terminal (unit: mm (inch))
A2: Mechanical contact
C: 5 V pulse (sensitivity 2 V)
D: 12 V/24 V pulse (sensitivity 5 V)
H: Two-wire current pulse
5.5 max.
(.22)
4 min.
(.16)
3.2 (.13) dia.
[2] OUTPUT
A1: High frequency open collector (max. 100 kHz)
A2: Low frequency open collector (max. 30 Hz)
M: 5 V pulse
INPUT SPECIFICATIONS
Excitation: 12 V DC @20 mA, shortcircuit protection
■ Open Collector
N: 12 V pulse
Maximum frequency: 100 kHz
P: 24 V pulse
Pulse width time requirement: ≥ 5 μsec. for ON and OFF
M6NPP SPECIFICATIONS
ES-7919 Rev.6 Page 1/5
http://www.m-system.co.jp/