P r e l i m i n a r y I n f o r m a t i o n
Integrated
Circuit
Systems, Inc.
M660-02
DUAL SAW, SELECTABLE FREQUENCY VCSO
GENERAL DESCRIPTION
PIN ASSIGNMENT (9 x 14mm SMT)
The M660-02 is a dual SAW, selectable frequency
VCSO frequency source for low-jitter clock
generation. An integrated SAW (surface
acoustic wave) delay line implements the
high-Q VCO (voltage controlled oscillator)
5
4
6
function, which results in low output phase
M660-02
M660
noise and very low jitter. The M660-02 is available in
a range of center frequencies from 500 to 700MHz.
Minimum pull-range is ±50 ppm (wider pull-range is
available). The M660-02 is well suited for phase-locked
loop implementations, clock and data recovery circuits,
and other timing applications in telecom and optical
fiber networking systems (e.g., OC-48, OC-192).
(Top View)
1
2
3
Figure 1: Pin Assignment
FEATURES
Sample of Available Output Frequencies
◆ Two integrated SAW devices
VCSO Center Frequency1 (MHz)
Applications
◆ Selectable output frequency
622.0800
625.0000
644.5313
669.3265
SONET/SDH
Gigabit Ethernet
◆ Supports multi-rate optical interface requirements
◆ VCSO center frequencies from 500 to 700 MHz
(Specify center frequency at time of order)
Gigabit Ethernet FEC
SONET/SDH FEC
◆ Low phase jitter 0.19ps rms typical (50kHz-80MHz)
◆ Low phase noise -70dBc/Hz @ 1kHz offset
◆ Differential 3.3V LVPECL output
Table 1: Sample of Available Output Frequencies
Note 1: Specify VCSO center frequency at time of order
◆ Single 3.3V power supply
◆ Small 9 x 14mm SMT (surface mount) package
BLOCK DIAGRAM
M660-02
M660
SAW Delay Line
Phase
Shifter
VCSO
FOUT
VIN
nFOUT
SAW Delay Line
Phase
Shifter
VCSO
F_SEL
Figure 2: Block Diagram
M660-02 Datasheet Rev 3.0
Revised 10Apr2003
M660-02 Dual SAW, Selectable Frequency VCSO
Integrated Circuit Systems, Inc. ● Communications Modules ● www.icst.com ● tel (508) 852-5400