T Series Data Sheet
500 Watt AC-DC Converters
®
Features
• Universal AC input range 70 to 255 VAC with PFC
• Class I equipment
• DC output for 24 and 48 V loads
• Battery charging for 24 and 48 V batteries with remote
temperature control
• 4 kVAC I/O electric strength test voltage
• Telecom rectifier applications
• Very high efficiency, typically 93%
• Power factor >0.96, harmonics according to IEC/EN
61000-3-2, low RFI
• No inrush current, hot swap capability
• High power density, rugged mechanical design, all
boards covered with a protective lacquer
• Very compact 19" cassette (28 TE, 3 U, 160 mm)
Safety according to IEC/EN 60950-1 and UL/CSA
60950-1 2nd Ed.
111
4.4"
3 U
141
5.6"
28 TE
168
6.6"
output voltage is backed-up by a battery. The float charge of the
battery can be set by a cell-voltage selector switch according to
the battery type used. These converters are equipped with a
temperature sensor input, in order to improve the life
expectancy of the battery.
Description
The T Series converters are electrically isolated AC-DC
converters with an output power of up to 550 W. For higher
power requirements several converters may be connected in
parallel.
The rectifier models are suited for DC-bus applications at
constant voltage. As the output voltage is SELV, even
electrically non-isolated switching regulators, such as the PSx
models, may be connected to the output.
The input is ideally adapted to the mains: Full power factor
correction, no inrush current, low RFI level, and high transient
and surge immunity are key design features. A T Series
converter behaves similar to a resistive load.
The LT/UT1701 models are especially optimized to build
distributed power systems together with the 48Q, CQ, or CP
Series DC-DC converters, as the signalling capabilities of
both families are matched. Distributed power systems have
as one advantage less power losses over load lines and fewer
regulation problems.
The LT models can be operated from a universal AC-input
range from 85 to 255 VAC. It is the preferred type for 230 VAC
mains, whereas the UT models are optimized for 110/
120 VAC mains. The output delivers an electrically isolated
Safety Extra Low Voltage (SELV) and is short-circuit and no-
load proof. Depending on the type, two output characteristics
are available, intended either for rectifier applications or for
battery charging purposes.
Power-One also offers backplanes for fast and simple set-up
of 19" DIN-rack systems with T Series converters; see
Accessories.
The latter types can be integrated into systems, where the
Table of Contents
Page
Page
Different Configurations and Applications ....................... 18
Electromagnetic Compatibility (EMC) .............................. 21
Environmental Conditions ............................................... 22
Mechanical Data ............................................................... 24
Safety and Installation Instructions .................................. 25
Description of Options ..................................................... 28
Accessories ...................................................................... 29
Description ......................................................................... 1
Model Selection .................................................................. 2
Functional Description ....................................................... 3
Electrical Input Data ........................................................... 4
Electrical Output Data ......................................................... 6
Control Features of the Battery Chargers ........................ 11
Auxiliary Functions ............................................................ 13
BCD20023 Rev AB, 02-Nov-2010
Page 1 of 31
www.power-one.com