LT1036
Logic Controlled Regulator
U
DESCRIPTIO
The LT®1036 features two positive regulators in the same
package. The 12V main regulator offers excellent
performance while supplying load currents up to 3A, and
the 5V auxiliary regulator provides similar performance
while supplying lighter loads of 75mA. The main regulator
has the additional feature of being under the shutdown
control of a logic signal. When the enable pin is taken to a
low logic level, the main regulator shuts down and its
output voltage goes to near 0V. During this command, the
auxiliary output is unaffected by the main regulator’s
condition and continues to provide a 5V output.
FEATURES
■
Two Regulated Outputs:
12V at 3A
5V at 75mA
■
2% Output Voltage Tolerance
■
60dB Ripple Rejection
0.7% Load Regulation
TTL and CMOS Compatible Logic Control
100% Thermal Burn-In on All Devices
■
■
■
The main output has current and power limiting combined
with thermal shutdown to make it virtually blowout proof.
The auxiliary output is not affected by the thermal
shut down mechanism or the state of the main output,
allowing it to be used as a back-up in case of overloads or
shorts on the main supply.
U
APPLICATIO S
■
Power Supply Sequencing
■
Remote On/Off Power Control
■
Selective System Power During Emergency
Power Operation
Memory Power Supply with Back-Up
The logic input of the LT1036 (enable pin) has a 1.6V
threshold and can be driven from a high source
impedance. This allows it to be driven by most logic
families, including TTL and CMOS.
■
Foradual5VversionoftheLT1036,pleaseseetheLT1035
data sheet.
, LTC and LT are registered trademarks of Linear Technology Corporation.
U
TYPICAL APPLICATIO
Guaranteed Load Current,
12V Output
Functional Diagram
5
4.5
4
12V
5
2
1
4
V
OV
IN
IN
OUT
AUX
3.5
3
LT1036
ENABLE
EN
5V
GND
3
2.5
2
LOGIC
1.5
1
LT1036M/1036C • FD01
0.5
0
14
22
INPUT VOLTAGE (V)
26 28
16 18 20
24
30
LT1036M/1036C • FD02
1036fa
1