LT1021
Pre c isio n Re fe re nc e
U
DESCRIPTIO
EATURE
S
F
The LT®1021 is a precision reference with ultralow drift
and noise, extremely good long term stability and almost
total immunity to input voltage variations. The reference
output will both source and sink up to 10mA. Three
voltages are available: 5V, 7V and 10V. The 7V and 10V
units canbeusedas shuntregulators (two-terminalzeners)
with the same precision characteristics as the three-
terminal connection. Special care has been taken to mini-
mize thermal regulation effects and temperature
induced hysteresis.
■
Pin Compatible with Most Bandgap Reference
Applications, Including Ref 01, Ref 02, LM368,
MC1400 and MC1404 with Greatly Improved
Stability, Noise and Drift
Ultralow Drift: 5ppm/°C Max Slope
Trimmed Output Voltage
Operates in Series or Shunt Mode
Output Sinks and Sources in Series Mode
Very Low Noise: <1ppm P-P (0.1Hz to 10Hz)
>100dB Ripple Rejection
Minimum Input/Output Differential of 1V
100% Noise Tested
■
■
■
■
■
■
■
■
TheLT1021references arebasedonaburiedzenerdiode
structure that eliminates noise and stability problems
associated with surface breakdown devices. Further, a
subsurface zener exhibits better temperature drift and
time stability than even the best bandgap references.
O U
PPLICATI
A/D and D/A Converters
Precision Regulators
Digital Voltmeters
Inertial Navigation Systems
Precision Scales
Portable Reference Standard
S
A
■
Unique circuit design makes the LT1021 the first IC
reference to offer ultralow drift without the use of high
power on-chip heaters.
■
■
■
■
■
The LT1021-7 uses no resistive divider to set output
voltage,andthereforeexhibits thebestlongtermstability
and temperature hysteresis. The LT1021-5 and LT1021-
10areintendedforsystems requiringaprecise5Vor10V
reference with an initial tolerance as low as ±0.05%.
, LTC and LT are registered trademarks of Linear Technology Corporation.
U
O
TYPICAL APPLICATI
Typical Distribution of Temperature Drift
24
Basic Positive and Negative Connections
DISTRIBUTION
OF THREE RUNS
21
18
15
12
9
LT1021
(7 AND 10 ONLY)
LT1021
GND
V
IN
IN
V
OUT
IN
OUT
NC
OUT
GND
–V
OUT
–
V
– (V )
OUT
6
R1 =
R1
I
+ 1.5mA
LOAD
3
–15V
(V )
–
1021 TA01
– 0
–5 –4 –3 –2 –1
0
1
2
3
4
5
OUTPUT DRIFT (ppm/°C)
1021 TA01
1