Spec No.: JELF243B_0044J-01
P7/9
12.4 Reworking with soldering iron
The following requirements must be met to rework a soldered product using a soldering iron.
Item
Requirement
150°C/approx. 1 min
350°C max.
Pre-heating
Tip temperature of soldering iron
Power consumption of soldering iron
Tip diameter of soldering iron
Soldering time
80 W max.
ø3 mm max.
3 s (+1 s, -0 s)
2 times max.
Number of reworking operations
* Avoid a direct contact of the tip of the soldering iron with the product. Such a
direction contact may cause cracks in the ceramic body due to thermal shock.
12.5 Solder volume
Solder shall be used not to be exceeded the upper limits as shown below.
An increased solder volume increases mechanical stress on the product. Exceeding solder volume may cause the failure of
mechanical or electrical performance.
12.6 Product's location
The following shall be considered when designing and laying out PCBs.
(1) PCB shall be designed so that products are not subject to mechanical stress due to warping the board.
[Products direction]
Products shall be located in the sideways direction (length: a < b) to the mechanical stress.
a
b
Poor example
〈
〉
Good example
〈
〉
(2) Components location on PCB separation
It is effective to implement the following measures, to reduce stress in separating the board.
It is best to implement all of the following three measures; however, implement as many measures as possible to reduce
stress.
Contents of measures
Stress level
A > D*1
A > B
(1) Turn the mounting direction of the component parallel to the
board separation surface.
(2) Add slits in the board separation part.
(3) Keep the mounting position of the component away from the
board separation surface.
A > C
*1 A > D is valid when stress is added vertically to the perforation as with hand separation.
If a cutting disc is used, stress will be diagonal to the PCB, therefore A > D is invalid.
MURATA MFG CO., LTD